Headphone Operation (Continued)
3.Adjust the Headphones to Fit Your Head Repeat the following to adjust the headband to fit:
A.Spread the ear pads apart and place the headphones on
your head. Observe the “L” and “R” indicators.
B. Grab the ear pads and use your thumb and forefinger to slide the adjusters up or down until a comfortable fit is achieved.
Standard Headphone Operation
1
1. Headphone Radio Operation
Your MovievisionTM headphones can be used as an FM radio receiver. Repeat the following procedures to listen to FM radio broadcasts.
A. Move the Power/Selector switch (1) from the OFF posi- tion to the RAD (Radio) position.
B. Rotate the tuning knob (2) to the desired FM radio station.
Note: FM radio stations are always received in Stereo Mode. C. Adjust the volume knob (3) to the desired volume level.
1
PWR
OFF RAD MOV
2. Listening to What is on the Viewing Screen
To use the MovievisionTM headphones with the source select- ed (FM Stereo/Video) repeat the following procedures.
A. Move the Power/Selector switch (1) to the MOV (Movie) position.
B. Rotate the tuning knob (2) until the headphone sound matches what is showing on the viewing screen.
C. Adjust the volume knob (3) to the desired volume level.
Note: If the transmitting frequency has been changed in the screen housing, repeat step “B” to
10
PWR
OFF RAD MOV
3. Turn OFF the Headphones when Finished
The batteries supplied with your MovievisionTM headphones will last for approximately 10 hours of continuous use. Forgetting to turn “OFF” the headphones, when not in use, will decrease the battery life.
1
PWR
OFF RAD MOV
4. Connecting a Second Set of Headphones
Your MovievisionTM headphones have a plug receptacle locat- ed at the bottom of the “R” ear pad. (4) A second set of per- sonal type headphones (Must have 3.5 mini male type plug) can be connected at this point.
Note: When a second pair of headphones are attached, the tuning and audio level is controlled by the MovievisionTM headphone.