Magnadyne MV-1002 owner manual Domelight Operation, Transmitter Frequency Selection

MV-VCR102UM 1/17/02 10:01 AM Page 8

Viewing Screen Controls and Functions

7. Transmitter Frequency Selection: Car Radio Interface:

The MovievisionTM viewing screen transmits a signal that is received by the MovievisionTM headphones and can also be received by the vehicle’s car radio. There are 3 fre- quencies available for use but only one can be used at a time. When you are listening to a movie using the wireless MovievisionTM headphones, it is possible that you could travel through an area where interference between the screen transmitter and the headphone receiver is at an un- acceptable level. If this occurs, you can use the 3 position frequency switch located in the roof housing to select a different frequency that may have less or no interference. Each time you change the transmitting frequency, the headphone/car radio receiver will have to be re-tuned to the new frequency. The 3 frequencies available for use are 89.7mhz, 90.1mhz or 90.5mhz. (For further information on headphone tuning, consult the “Headphone Operation” section of this manual)

The signal transmitted from the MovievisionTM screen can be received by the existing FM car radio. This listening mode provides a much higher quality of sound for all. To listen to the MovievisionTM signal through the vehicle stereo system, repeat the following procedures;

A. Turn “ON” the MovievisionTM system and insert a tape or attach an auxiliary signal source to view on the screen.

B. Turn “ON” the FM radio in your vehicle and tune the radio to one of the 3 frequencies transmitted by the MovievisionTM system. (89.7mhz - 90.1mhz - 90.5mhz)

C. Adjust the volume and tonal qualities to suit your lis- tening taste.

Transmitter Frequency Selection Switch

Domelight Operation

Domelight Operation:

(Applies to MovieVision flip-down screen with domelights built-in only.)

The domelights located in the MovieVision screen housing will illuminate whenever the vehicle doors are open just as the original domelight did.

To activate the domelights while the vehicle is in motion, press the domelight switch next to the desired domelight.

Note: Most American made vehicles (Ford, Chevrolet, Dodge) have a dashboard light dimmer switch that can be rotated to the maximum position and the domelights will illuminate. Most Japanese or Korean made vehicles do not have this switch and the lights will have to be turned on manually as mentioned above.

Domelight Switch

8