Domelight Operation (Continued)
Replacing Domelight Bulbs:
To replace a domelight bulb, repeat the following procedure. Warning! in some cases, the domelight maybe hot, proceed with caution.
1.Use your fingernail to pull the lever at the end of the domelight lens forward and downward this will release the lens to expose the bulb.
2.Use a pencil to pry out one end of the bulb then pull the remaining end of the bulb out of it’s clip. Do not use any metal device to remove the bulb as you may short the ter- minals together.
3.To replace the bulb, place the metal ends of the new bulb onto the metal clips and gently press inward until the bulb ends are seated into the clips.
4.Replace the lens by setting the tab end into the slot and then pressing the clip end into place.
Warning! Only replace the bulb with the same size and wattage that you took out. Altering the size, shape or wattage will result in a damaged housing (melting). Use only Sylvania or GE model DE3021 for replacements.
Removing Domelight Cover
Removing Bulb
Headphone Operation
Your MovievisionTM entertainment system is supplied with two (2) MovievisionTM headphones. The correct operation, care and maintenance of the headphones is critical to their ability to provide the user with a lifetime of operation. Misuse, abuse and neglect of the headphones will result in poor performance and premature failure. Please read through the simple operation and maintenance instructions enclosed.
WARNING!
•Do not throw the headphones.
•Do not get the headphones wet or submerse them in any liquid.
•Do not use the headphones as a hammer.
•Do not step, stand or sit on the headphones.
•Do not lay heavy objects on the headphones.
•Refrain from turning the volume of the headphones to the maximum position, this may result in ear damage.
1. Install the Batteries (AAA Type)
To install the “AAA” batteries supplied, repeat the following procedure:
A. Hold the headphones in one hand and place your thumb onto the gripping arrow on the battery holder cover.
B. Press down on the gripping arrows while pulling down- ward on the battery door. Slide the door away from the headphones to expose the battery holder cavity.
C. Place the batteries into the holder following the directions engraved inside the holder. Observe battery polarity.
9