Legacy Car Audio Car CD Player owner manual SET the Clock, Select Mode, Mute, Equalization

Page 8

SET THE CLOCK

Press DSP button (9) to change the display to clock display. Press it again to return to previous display. In clock display, press and hold the DSP button (9) for several

seconds until the clock display flashes. Press VOL (5) to change minutes or VOL (4) to change hours.

SELECT MODE

Press SEL button (3) to change audio mode through volume, bass, treble, balance, and fader modes. Use VOL (4) and VOL (5) buttons to adjust the selected mode. When mode has not been adjusted for several seconds, display returns to normal radio or CD display.

 

VOL

 

BAS

 

TRE

 

BAL

 

FAD

 

 

(Volume)

 

(Bass)

 

(Treble)

 

(Balance)

 

(Fader)

 

 

 

 

 

 

 

 

 

 

 

Volume

Adjust volume level by using VOL (4) and VOL (5) buttons.

Note: The unit is initially set to volume mode.

Bass

Press SEL button (3) one time. Adjust bass level by using VOL (4) and VOL (5) buttons.

Treble

Press SEL button (3) two times. Adjust treble level by using VOL (4) and VOL

(5) buttons.

Balance

Press SEL button (3) three times. Adjust sound balance between left and right speakers by using VOL (4) and VOL (5) buttons.

Fader

Press SEL button (3) four times. Adjust sound balance between front and rear speakers by using VOL (4) and VOL (5) buttons.

MUTE

Press MUT button (6) to mute down sound. Press it again to release this mode and recover previous volume level.

SELECT MODE

Press MOD button (7) to change radio or CD mode. During CD operation, press BND button (10) to switch to radio mode. During radio operation, when a compact

disc is inserted in the disc slot (16), press button (14) to switch to CD mode and start playing.

EQUALIZATION

Press EQ button (19) to turn to equalization function and to select desired audio mode. There are four kinds of mode as below:

FLAT ROCK CLASSIC POP EQ OFF

LIQUID CRYSTAL DISPLAY

The LCD (20) can show the current state of the unit.

8

Image 8
Contents Page Contents Installation Installing the unitDIN REAR-MOUNT Method B Removing the unitInstalling the Front Panel Removing the Front PanelWiring Connection For 2 X 7W SystemOperation General OperationON/OFF Faceplate ReleaseSelect Mode SET the ClockMute EqualizationReset Button Function Flashing LEDRadio Operation BandSelect Station LOCAL/DISTANTCD Operation Specification GeneralCD Player RadioTrouble Shooting Symptom Cause No powerSolution Not on