NOTE FOR THE OPENING OF THE FRONT PANEL
In this set, the front panel is lowered to below the bottom face when it is opened.
When servicing the set, place it on a stand having a height of about 2 cm.
stand
TEST MODE
1.Turn on the power.
2.Push “4” on the card remote control for 2 sec.
3.Push “5” on the control for 2 sec.
4.Push “1” on the control for 2 sec. (The TEST MODE is entered.)
5.Push the “OPEN/CLOSE” switch on the control for 2 sec.
6.The front panel detouch position is set. (No display appears at this time.)
7.Turn off the power and disassemble the set.
CDX-M620/M670
| TABLE OF CONTENTS |
|
1. GENERAL | 4 | |
2. DISASSEMBLY |
| |
Front Panel Assy (Normal) | 16 | |
Front Panel Assy (Inoperative) | 16 | |
CD Mechanism Block, Flexible Board | 16 | |
Sub Panel (CD) Sub Assy | 17 | |
Motor Block Assy, Cam (R) Assy | 17 | |
Main Board | 18 | |
Heat Sink | 18 | |
Chassis (T) Sub Assy | 19 | |
Lever Section | 19 | |
Servo Board | 20 | |
20 | ||
Floating Block Assy | 21 | |
Optical | 21 | |
3. PHASE ALIGNMENT |
| |
Arm | 22 | |
Cam (L) | 22 | |
Motor Block | 23 | |
| ||
| and Arm | 23 |
Arm | 24 | |
Cam (R) | 24 | |
4. DIAGRAMS |
| |
IC Pin Descriptions | 25 | |
Circuit Boards Location | 33 | |
Block Diagram | 34 | |
Block Diagram | 35 | |
Block Diagram | 36 | |
Printed Wiring Boards | 38 | |
Schematic Diagram | 40 | |
Schematic Diagram | 41 | |
Printed Wiring Boards | 42 | |
Schematic Diagram | 44 | |
45 | ||
Schematic Diagram | 46 | |
Schematic Diagram | 47 | |
Printed Wiring Board | 48 | |
Schematic Diagram | 49 | |
50 | ||
Schematic Diagram | 51 | |
Printed Wiring Board | 52 | |
Schematic Diagram | 53 | |
5. EXPLODED VIEWS |
| |
Chassis Section | 56 | |
Cam Section | 57 | |
Main Board Section | 58 | |
59 | ||
60 | ||
CD Mechanism Section (1) | 61 | |
CD Mechanism Section (2) | 62 | |
CD Mechanism Section (3) | 63 | |
6. ELECTRICAL PARTS LIST | 64 |
3