Drive + Play operates much like the iPod itself. The Control Knob mimics the iPod’s Click Wheel, and its software uses a similar
To make selections on the Text Display, you simply turn the Control Knob’s Scroll Ring to highlight a desired menu item. Turn the Scroll Ring to the right to scroll down, and to the left to scroll up. Press the (center) Select button once to confirm your selection.
Depending on your selection, this display may show:
•a list of settings or menu operation, or
When in any of the “settings” menus:
•a highlighted setting with a choice of values, or
•a highlighted setting with a check box, or
•a graphic display which may be adjusted using the Scroll Ring.
Pressing the (center) Select button again will select the next highlighted setting (to the right) or go back to the beginning if all settings have been viewed, or set the check box on or off (i.e., check or uncheck). If a graphic display appears, use the Scroll Ring to adjust the setting.
After making your adjustment or selection, you may press the (top) Menu button to go to the previous menu. If no but- tons are pressed within 10 seconds, the Now Playing screen will appear. At this point, pressing the Menu button will take you back to the screen of your previous selection. Repeated Menu presses will take you back to the Drive + Play Menu.
Initial Setup
NOTE: Please refer to Drive + Play’s display screen as you make initial settings. Also refer to your iPod User’s Guide for operation information.
Power On
1.With the main volume turned down (on your audio sys- tem), power on your entire mobile audio system and then turn on Drive + Play by pressing the (bottom) Play/Pause Button. If everything is operating correctly, the iPod screen will display the following message:
OK to disconnect.
2.Drive + Play’s Text Display will show the Harman Kardon splash screen first, followed by the Now Playing screen. What the Now Playing screen displays next depends on the following conditions:
OPERATION
•Drive + Play will tell your iPod to play the same selection as when it was last turned off. If you plugged your iPod into Drive + Play while it was playing, Drive + Play will tell the iPod to play the current song without interruption.
•However, if nothing was playing when your iPod was last turned off or when it was plugged in, Drive + Play will tell the iPod to begin playing the first song in its Songs database.
Setting FM Transmission
FM Settings can be accessed from the Main Menu or later within the Settings Menu.
•To turn FM Transmission on or off:
Drive + Play Menu > FM Settings > FM Transmitter> select On (default) or Off.
•To change the preset FM Frequency:
Drive + Play Menu > FM Settings > FM Frequency > select
88.1(default), 88.3, 88.5, 88.7, 88.9 or Custom (default = 91.7MHz or last setting).
NOTE: If the preset FM frequencies are already assigned to FM stations in your listening area, then use Custom FM Frequency (below) to select an unused frequency. The default setting is 91.7MHz.
•To select a Custom FM Frequency:
1.Drive + Play Menu > FM Settings > Custom Frequency.
2.The FM Frequency graphic display will appear. Scroll to select a desired FM frequency.
Setting Shuffle
You can set Drive + Play to shuffle (randomly play) iPod songs or albums as follows:
•Drive + Play Menu > Settings > Shuffle > select Off (default), Songs or Albums.
Setting Repeat
You can set Drive + Play to repeat the current iPod song or all songs in a playlist or album as follows:
NOTE: When browsing by Artists, Genres or Composers, selecting Repeat All will repeat the album that contains the selected song.
•Drive + Play Menu > Settings > Shuffle > select Off (default) > One > All.
continued on next page...
OPERATION 9