doors. (Airbag locations are marked with “SRS” logos.) Be careful not to crimp or cut the cable.
3.Bring the cable out from the trim near the firewall and route it under the carpet toward the dashboard or console. Coil any excess cable in a hidden location, such as under the carpet, keeping it away from any vehicle pedals or controls. Secure the excess cable with wire ties.
4.Bring the end of the cable out at the SIRIUS radio location. Leave yourself enough cable so you can easily connect it to the antenna connector of the SIRIUS radio or vehicle cradle/dock.
Convertible Antenna Cable Routing Procedure
Figure 7 shows how the antenna cable should be routed from the antenna to your SIRIUS radio in a convertible.
1.Bring Cable from Antenna Into Inside
of Trunk Lid
2.Tape Cable Along Inside of Lid to Hinge Strut
6.Bring Cable Out To SIRIUS Radio Location
5. Bring Cable out from Trim and Route Under Carpet to Dashboard or Console.
4. Route Cable from Trunk Under Interior Trim, into Cabin and Towards Front of Vehicle
3.Tie Cable to Hinge Strut, Allowing Slack for Lid to Open and Close. Route Cable Into Cabin Through Existing Wire Channel.
Figure 7
Follow these detailed cable installation instructions: