❐Preparation
Warning
If your vehicle is equipped with air bag and/or
Before attempting installation of this electronic component, contact your vehicle dealer or manufacturer to determine the required procedure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVATION OF THE
•Disconnect the cable from the negative
•Remove Mounting Collar q from the main unit temporarily, which are already mounted at shipment.*
Caution
Various settings that have been stored in the memory in other
Therefore, we recommend to make a record of or to back up the settings before disconnecting the terminals.
After completing installation of the main unit, set the equip- ment again according to the record.
•Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚.
❐Installation Hardware
No. | Item | Diagram Q’ty |
q Mounting Collar* | 1 | |
w Plain washer (5 mmø) | 2 | |
e Spring Washer (5 mmø) | 2 | |
r Hex. Nut (5 mmø) | 2 | |
t Rear Support Strap | 1 | |
y | Hex. Bolt | 1 |
(5 mmø ⋅ 25 mm) | ||
u | Toothed Lock Washer | 1 |
(5 mmø) | ||
i | Removal Tool | 2 |
0 – 30°
❐Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having an opening as shown below. The dashboard should be 4.75 mm {3/16”} – 5.56 mm {7/32”} thick in order to be able to support the unit.