Panasonic CQDF202 manual Power, Volume Level Meter, Loudness, Mute, Time Reset

GN	Power and Sound Controls
E
L
I
S	Power
H
1	Turn the key in the ignition until the accessory in-	AC	C
	dicator lights.		ON

Power on: Press [SOURCE] (PWR).

Power off: Press [SOURCE] (PWR) again and hold.

Note:

≥When the power is switched on for the first time, a demonstration message appears on the display.

To cancel this display, press [DISP] (display).

SCAN		CQ-DF202W
AUTO·P	REMOTE		45W X 4	OPEN

RANDOM

	VOL	BAND								REP
SEL		TUNE								PWR
		TRACK								SOURCE
		LOUD	CD RECEIVER WITH CHANGER CONTROL
			7	8	9	10	11	12		LEVL
		MONO/LOC							CLOCK
		MUTE	1	2	3	4	5	6	DISP

									Clock Basics		G
											E
											N
											L
											I
Audio Mode									The 12-hour system is used for the clock.		S
											H
(Bass/Treble/Balance/Fader)									Initial Time		2
1 Press [SEL] to select the audio mode.									1Press [DISP] (CLOCK).
Regular mode										(Clock display.)
Volume		Bass		Treble
Fader				Balance
[% TUNE], [$ TUNE] (Hours, minutes)								[DISP] (CLOCK)
		SCAN				CQ-DF202W
		AUTO·P REMOTE							45W X 4	OPEN
										RANDOM
	VOL	BAND								REP
SEL		TUNE								PWR
		TRACK								SOURCE
		LOUD	CD RECEIVER WITH CHANGER CONTROL
				8	9	10	11			LEVL
		MONO/LOC 7						12	CLOCK
		MUTE	1	2	3	4	5	6	DISP

Volume	Level Meter
[" VOL]: Up	When the power is on, the level of sound sources,
[# VOL]: Down	such as radio and CD, is displayed.
Press and hold for rapid adjustment.	Press [LEVL] (level) to change the level meter dis-
	play.

	(Default)
Volume level (0 to 40)	Pattern 1	Pattern 2	Pattern 3
	Pattern off		Pattern 4

2Press [" VOL] or [# VOL] to change each level.

Bass:

Adjustable range: j12 dB to i12 dB (by 3 dB step)

Treble:

Hours

2Press and hold [DISP] (CLOCK) for more than 2 seconds.

(Hours blink.)

3Press [% TUNE] or [$ TUNE].

(Hours set.)

Minutes

Loudness

Press [LOUD] to enhance bass and treble tones at low or medium volume.

LOUD

Press [LOUD] again to cancel.

Mute

Press [MUTE] to mute the sound completely.

MUTE

Press [MUTE] again to cancel.

Anti-volume-blast circuit:

When the power is switched off and on again, the volume slowly rises to the previous level. The anti-volume-blast circuit will not work when the volume level is set lower than position 20 on the display.

Adjustable range: j12 dB to i12 dB

Balance: (by 3 dB step)

R (right speaker) or L (left speaker)

Adjustable range:	Balance center
1 to 15 (by 1 dB step)

Fader:

F (front speaker) or R (rear speaker)

Adjustable range:	Fader center
1 to 15 (by 1 dB step)

Note:

≥If no operation takes place for more than 5 seconds in audio mode (2 seconds in volume mode), the dis- play returns to the regular mode.

(Minutes blink.)

5Press [% TUNE] or [$ TUNE]. (Minutes set.)

6Press [DISP] (CLOCK).

(End.)

Note:

≥Press and hold [% TUNE] or [$ TUNE] for more than 2 seconds to change numbers rapidly.

Time Reset

Press and hold [DISP] (CLOCK) for more than 2 seconds to activate the time setting mode to reset the time.

Then, repeat steps 3 to 6.

10

11

CQ-DF202W CQ-DF202W