E N G L I S
Troubleshooting (Continued)
E N G L I S
H
9
❐Radio
Trouble
Much noise in FM stereo and monaural broad- casts.
Preset station is reset.
❐CD
Cause/Step
Station is too far, or signals are too weak.
➡Select other stations of higher signal level.
The motor antenna relay control lead is not connected correctly.
➡If there is a motor antenna in the car, connect the motor antenna relay control lead to the motor antenna lead that is installed in the car correctly.
The radio antenna is not extended enough.
➡Extend fully the radio antenna.
Battery cable is not correctly connected.
➡Connect the battery cable to the terminal that is always active.
❐CD (Continued)
Trouble
Sound skips due to vi- bration.
Disc is not ejected.
Time is counted but no sound comes out.
Cause/Step
Mounting angle is over 30o.
➡Adjust mounting angle to less than 30x.
Instable mounting.
➡Mount the unit securely with the mounting parts, referring to the section on installation.
≥Disc is defective.
≥Mechanical trouble.
➡Press [OPEN] to open the panel and press [<] (eject). If normal op- eration is not restored, call the store where you purchased the unit or the nearest service station to ask for repairs.
The first track of a mix mode disc was reproduced. (Mix mode is a for- mat in which data except music is recorded on the first track and music data is recorded on other than the first track in a session.)
➡Play back music data recorded on other than the first track.
H
10
Trouble | Cause/Step |
Disc is in the CD com- partment but no sound is made, or disc is ejected automatically.
Sound skips, bad sound quality. (e.g. caused by noise)
Disc is upside down.
➡Place disc in the correct direction with the label side up.
≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD Media (CD- R,
A disc that has data other than
➡Discs that have CD-DA type data should be used.
➡The unit may not successfully play back a
≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD Media (CD- R,
➡The unit may not successfully play back a
❐Sound Setting
Trouble
No sound from left, right, front or rear speakers.
Left and right sounds are reversed in stereo listening.
Cause/Step
Left and right balance, or front and rear balance is off on one side.
➡Adjust balance/fader setting as appropriate.
Cables are not correctly connected.
➡Connect the cables correctly.
The right speaker wire is connected to the left speaker and the left speaker wire to the right speaker.
➡Connect the speaker wires to the correct ones.
18 |
| 19 | ||
|
|
| ||
|
|
|
|
|