Service

Device maintenance is essentially limited to cleaning the exterior.

DEVICE CALIBRATION

The calibration interval is dependent on operational demands made on it and should be carried out every 1 to 2 years. The calibration can be carried out by ESC Kathrein customer service, see below.

EXTERIOR CLEANING

Clean the exterior of the device using a soft cloth, ﬂuff-free duster or a brush. In case of heavier soiling it is also possible to use alcohol or a mild soap solution. Under no circumstances is it allowed to use solvents such as thinners, acetone, etc., as otherwise plastic parts and markings may be damaged.

INTERIOR CLEANING

Caution!

As it is necessary to open the device to clean the interior, this work is only allowed to be undertaken by aut- horised service personnel! The device should be freed of dust deposits inside the device every 1 to 2 years to ensure correct ventilation. The cleaning interval is based on the length of time the device is operated each day and the amount of dust in the premises. It is necessary to remove the back panel or the control panel for cleaning. Dust deposits can be removed using a brush or grease-free compressed air.

FUNCTION TEST

It is recommendable to check the nominal data at appropriate intervals. The data and tolerances are given in the technical data.

MEASURING EQUIPMENT REQUIRED

- TV/SAT signal generator to check the level accuracy as well the analogue measurements and demodula- tion.

- DVB signal generator to check the level accuracy and digital measurements and demodulation.

STORAGE

The storage temperature range for the device is -40 ... +70°C.

During storage the device is to be protected against dust and moisture.