Audiovox 128-7902A manual Important/Antenna Installation

Page 10

Important/Antenna Installation

10

2. Important!

It is very important to make your power connection to a source that only supplies 12V when the vehicle key is in the accessory or ignition ON position. A connection to a 12V source that is always on, regardless of the key position, can lead to a battery drain if the CommanderMT System is left on when you leave your vehicle.

ACCESSORY

NOACCESSORY

POSITION

POSITION

Ignition Switch Accessory/On-Off Positions

3. Antenna Installation

Where to locate

Best reception is achieved with the antenna mounted on a flat portion of a metal vehicle roof with at least 12” x 12” of surface area and a minimum of 6” from a window or sunroof.

If the vehicle has roof racks or skid ribs, it may be necessary to mount the antenna off-center.

If the venicle roof does not provide sufficient metal surface area, then the antenna can be mounted on the metal trunk lid. It is recommended that it be mounted at least several inches from the rear window to ensure adequate clearance.

Image 10
Contents CommanderMT System Table of Contents Congratulations FCC Information Page CommanderMT Receiver Kit Components Installation/Wiring Precautions Setting Up and Installing Your Kit Cabling InterconnectionsInterconnect Diagram CablingAntenna Installation Important/Antenna InstallationCable routing Tools required CommanderMT Display Controller Installation Using the DIN Opening Trim Bezel Using the Snap-On Mounting Plate Connection Options Off Cable Routing and Component Installation Cable Routing and Component Installation XMRVRFM002 Warranty XMRVRFM002