Audiovox 128-7902A manual Using the DIN Opening Trim Bezel

Page 14

14

Display Controller Installation

The CommanderMT Display Controller can be installed using the DIN opening trim bezel or a snap-on mounting plate as shown below. The trim bezel permits in-dash or center console mounting, while the mounting plate can be used with optional custom brackets, such as swivel or vent mounts.

a.Using the DIN Opening Trim Bezel

Preferred location

Your CommanderMT Receiver Kit includes a DIN opening trim bezel for mounting the display controller into an existing dash- board or console opening.

Using the DIN Opening

Trim Bezel

Page 13 Page 15
Image 14
Page 13 Page 15
Contents CommanderMT System Table of Contents Congratulations FCC Information Page CommanderMT Receiver Kit Components Installation/Wiring Precautions Setting Up and Installing Your Kit Cabling InterconnectionsInterconnect Diagram CablingAntenna Installation Important/Antenna InstallationCable routing Tools required CommanderMT Display Controller Installation Using the DIN Opening Trim Bezel Using the Snap-On Mounting Plate Connection Options Off Cable Routing and Component Installation Cable Routing and Component Installation XMRVRFM002 Warranty XMRVRFM002
Top Page Image Contents