Audiovox 128-7902A manual Cable routing

Page 11

11

Caution: 1. Do not install the antenna inside the vehicle passen- ger compartment. Mounting the antenna in the passen- ger compartment either on the from dashboard, or on the rear window deck area will cause reception issues and must be avoided.

2.Mounting the antenna on a non-metalic surface will also result in severe degradation in reception.

If an appropriate antenna mounting location cannot be identified, contact your local retailer installation department for additional guidance.

Cable routing

Once you have mounted the antenna in the correct location, plan how to route the cable from this location to the receiver Inteconnect Cradle, avoiding blocked passages and any obstruc- tions that could kink, crimp, twist or chafe the cable. If the cable will come into contact with a rough metal opening, use a rubber grommet to prevent damage.

For antenna mounting locations at the front or middle of the roof, the cable can be routed down along the door jamb and into the car. In some cars, the cable may be brought into the vehicle through the grommet in the door jamb which carries the power window and power door lock wires. If the cable does not fit easily through this grommet, do not try to force it through. Instead, route the cable under the weather seal near the bottom of the door.

Antenna Installation

Image 11
Contents CommanderMT System Table of Contents Congratulations FCC Information Page CommanderMT Receiver Kit Components Installation/Wiring Precautions Cabling Interconnections Setting Up and Installing Your KitCabling Interconnect DiagramImportant/Antenna Installation Antenna InstallationCable routing Tools required CommanderMT Display Controller Installation Using the DIN Opening Trim Bezel Using the Snap-On Mounting Plate Connection Options Off Cable Routing and Component Installation Cable Routing and Component Installation XMRVRFM002 Warranty XMRVRFM002