Delphi SA10085 manual Final installation

Page 24

24

Section 5

For antenna mounting locations at the rear of the roof, the antenna cable can be routed into the vehicle through the trunk, as shown in

figure 10. Always route the cable under the weather seal near the lowest part of the trunk to help reduce possible water leaks.

Use pre-existing wiring channels created by the vehicle manufacturer whenever possible.

Rear Mounting Option

Figure 10. Route XM Antenna wiring as shown.

Final installation

Verify that the antenna is in its final desired position. The antenna contains a powerful magnet that will secure the antenna to a metal roof under normal driving conditions.

Image 24
Contents User FCC ID RS2SA10085 Welcome About Roady About DelphiAbout XM Contents Getting Started Activating Roady2 Roady2 Receiver Roady2 Display ScreenChannel name, channel number, artist name Basic Operations Turning Roady2 On and OffBasic Channel Selection Preview and select channels using the Tuning Wheel Changing the Display Save and Recall Artist Name and Song Title InformationFM Frequency only available when FM modulator is turned on MenuScreen Color ContrastAudio Level Antenna Aiming TuneSelectStock Ticker Direct TuneFactory Default Auto-OnAuto-Off Installation Roady2 Kit Set-upHooking up your Roady2 Receiver FM Modulator Wireless FM Modulator Direct ConnectCassette Adaptor Roady2 Installation Your Roady2 can be installed as followsSection Removing swivel mount from your dashboard Attach car mount to backAntenna Installation XM Antenna Set-upCable Routing Final installation Reference Taking Care of Your Roady2Troubleshooting No Signal If you see this on the display You shouldIf this happens You should Contacting Product Technical Support and Customer Service Available AccessoriesTechnical Information XM Satellite Radio Limited Consumer Warranty How you the Customer can get service How state law relates to the warranty