14 Setup
In this case, you will need to connect a ca- ble from the RF OUT socket to the antenna connector on your television. To ensure your television can also pick up existing analogue channels as well, you will need to connect a cable from your television antenna to the RF IN connector.
Tune your television set to channel 36 (or rarely 43) so that you can see the output from the digital receiver.
2.4.3 Connecting to your video cassette recorder
The digital receiver can also output video to another appliance such as a video cassette recorder or video receiver through an auxiliary SCART connector.
You will need to obtain a SCART cable to use the auxiliary SCART connector. Plug one end of the cable into the VCR socket on the digital receiver, and the other end into the match- ing socket on your video cassette recorder or suchlike.
2.5Switching on for the first time
Now that you have your digital receiver connected, you should plug it in to a mains socket. Ensure that your television set is turned on, so that you will be able to see the display from the digital receiver.
2.5.1 Inserting batteries in the remote control
To insert the batteries, open the battery compartment by remov- ing the lid, and then insert the batteries observing the polarity, which is marked on the base of the battery compartment.