Teac 9A10001300 CR-H250 owner manual Sig error rate Signal error rate

Page 23

5Press the ENTER button.

Fav Station (Favourite station)

As you tune in stations and listen to them the unit will memorize the top ten stations you listen to and list them at the top of the channel list. A Favourite station in the channel list has ‘ ’ displayed after the station name on the first line of the display.

Alphanumeric

This is the default order. Channels are listed by name with numbers first and then alphabetically by letters in the channel name.

Active station

This option will list active stations at the top of the channel list and channels that are in the list but have no service in your area to be listed last in the channel list.

Tidy station

This option will list active stations and remove any channels that are in the list but have no service in your area from the channel list.

qpreset

This option takes your top ten Favourite channels and assigns them to preset numbers 1 - 10.

This option is only available after ‘Fav Station’ option has been turned on. See above.

Sig error rate (Signal error rate)

This option shows the digital bit error rate (0-99) of the currently tuned channel. This is for information only and no adjustment is available. The lower the figure the better the quality of the received broadcast.

1While listening to a DAB broadcast press the FUNCTION/FM MODE button.

2Press the TUNING/PRESET/TIME button until ‘Sig error rate’ is displayed in the second line of the display.

3Press the ENTER button.

The digital bit error rate of the current tuned channel is displayed.

23

Image 23
Contents CR-H250 Before Use ContentsDiscs which can be played on this unit Compact DiscSubwoofer OUT jack How to connectConnections Speaker ConnectionsDigital OUT terminal AC Power CordRemote Control jack TAPE/AUX jacksFM Outdoor Antenna Connecting Antennas AM/FMAM Indoor Loop Antenna FM Indoor AntennaDipole Connecting Antennas DABDAB Indoor Antenna DAB Outdoor AntennaStop H, INFO, RDS MODE, Clear OPEN/CLOSE L, Auto TuningVOLUME, Select Names of Each ControlPower Pause J, FUNCTION, FM ModeTape Battery Installation Remote Control UnitBasic Operation Press the TONE/BAL button How to adjust TONE/BALANCE/DIMMERListening to CDs Search for a part of a track To suspend playback temporarily pause modeTo stop playback To skip to the next or a previous trackPress the y Play button to start programmed playback Programmed PlaybackTo check the programmed order Shuffle Playback Press the Shuffle button in the stop or play modeRepeat A-B Repeat PlaybackRepeat one track R1 Repeat All RaPress the TUNER/AUX 1/2 button to select ‘AUX 1’ or ‘AUX 2’ Time DisplayListening to the External Sources Press the Auto Tuning button Setting up your DAB TunerAuto Tuning Using the Channel List Station order Using Function ControlSig error rate Signal error rate Sw version Software version Preset tuneDRC value Manual tune DLS Changing Display SettingsListening to FM/AM FM Mode ButtonWithin 4 seconds, press the PROGRAM/ Memory button Preset TuningPreset Manually FM/AM/DAB Preset Automatically FM/AM onlyHow to select FM/AM preset stations How to select DAB preset stationsRDS Radio Text Program ServiceRDS Clock Time RDS Program TypePress the ENTER/SET button Press the TUNING/PRESET/TIME buttonPTY Search Affairs About DABPress the Time Mode button Setting the ClockRepeat and 3 to set the Off time Setting the TimerPress the Timer button Prepare for timer operationNormal display Sleep TimerSLEEP-90 80, 70 Tuner Section SpecificationsStandard Accessories Amplifier SectionTuner FM/AM TroubleshootingRemote Control Unit AmplifierCD Player 0704.MA-0906A