iPod control
English
Preparation:
Connect an iPod with the Direct cable for iPod
Controllable iPod/ software version
Connecting an iPod to the system
To connect the iPod
iPod | Direct cable for iPod | |
|
| |
|
| |
|
|
|
3rd generation iPod/ver. 2.2 – 2.3
4th generation iPod/ver. 3.0.2 – 3.1
5th generation iPod/ver. 1.0
(Video and photos cannot be displayed.)
iPod Photo/ver. 1.0 – 1.2 (Photos cannot be displayed.)
iPod mini/ver. 1.2 – 1.4
iPod nano/ver. 1.0
*Operation has been confirmed for software available at the end of February, 2007. We do not guarantee proper operation with our future products or upgraded software.
Note:
Do not attach or detach the iPod while iPod is on. Noise is generated which could damage the speakers.
Use a holder or other means to ensure the iPod does not move while the vehicle is in motion.
Do not leave the iPod for long periods of time where the inside of the vehicle will get hot.
Also refer to the installation manual for the iPod to be connected.
After turning the engine off (switching from ACC to OFF), always disconnect the iPod. If the iPod is left connected, its power may not turn off, causing its battery to run down.
Please note that no compensation will be provided for data lost from the iPod while it is used connected to the main unit.
The iPod is licensed for duplication and playback of material that is uncopyrighted, or may legally be duplicated or played for individual private use. Infringement of copyright is prohibited by law.
Do not connect iPod accessories such as a remote control unit or headphones while the iPod is connected to the main unit. They may not function normally in some cases.
The iPod can only play music data.
The iPod Shuffle is not compatible.
12
Dock connector port
The iPod cannot be operated with its own controls.
The iPod charges while it is connected to the main unit.
To disconnect the iPod
Detach while pressing.
Switch to iPod
Select [iPod] on the Audiovisual source operation screen.
( Operating Instructions)
The iPod operation screen is displayed.
Plays the track.
Note:
“Communication error” appears until the iPod is recognized after connecting the iPod, turning on the power of the main unit, or performing source selection on the main unit. This indicates there is nothing wrong with the main unit.
We do not guarantee operation of all the functions of the iPod to be connected.
Only iPods equipped with a dock connector can be connected.
is displayed even if only the connecting cable
12