Panasonic CQ-VX220W manual Troubleshooting, Possible cause a Possible solution

Page 41

Troubleshooting

If You Suspect Something Wrong

Check and take steps as described below.

If the described suggestions do not solve the problem, it is rec- ommended to take the unit to your nearest authorized Panasonic Service Center. The product should be serviced only by qualified personnel. Please refer checking and repair to professionals. Panasonic shall not be liable for any accidents arising out of neg- lect of checking the unit or your own repair after your checking.

Never take measures especially those other than indicated by italic letters in “Possible Solution” described below because those are too dangerous for users to handle themselves.

Warning

¡Do not use the unit in an irregular condi- tion, for example, without sound, or with smoke or a foul smell, which can cause ignition or electric shock. Immediately stop using the unit and consult your dealer.

¡Never try to repair the unit by yourself because it is dangerous to do so.

English

40

Common

Problem

No power to the unit

Sound is not

generated.

Noise

Noise is made in step

with engine revolutions.

Some operations are not

executable.

No sound from

speaker(s)

The speaker channels are reversed between right and left.

The power of the unit fails unintentionally.

Possible cause a Possible solution

The power cord (battery, power and ground) is connected in the wrong way. aCheck the wiring.

Fuse blows out.

aEliminate the cause of fuse blowout and replace the fuse with new one.

Consult your dealer.

MUTE is set to ON.

aSet MUTE to OFF.

The wiring of speaker lines is not correct, or a break or poor contact arises.

aCheck the wiring in accordance with the wiring diagram. (Installation

Instructions)

There is an electromagnetic-wave generator such as a cellular phone near the unit or its electrical lines.

aKeep the electromagnetic-wave generator such as a cellular phone away from the unit and the wiring of the unit. In case noise cannot be eliminated due to the wiring harness of the car, consult your dealer.

The contact of the ground lead is poor.

aMake sure that the ground lead is connected to an unpainted part of the chassis securely.

Alternator noise comes from the car.

aChange the wiring position of the ground lead. aMount a noise filter.

Some operations are not executable in particular modes such as menu mode.

aRead the operating instructions carefully and cancel the mode. If the unit is still out of order, consult your dealer.

There is a break, a short circuit, poor contact or wrong wiring regarding the speaker wiring.

aCheck the speaker wiring.

The speaker wiring is reversed between right and left.

aPerform the speaker wiring in accordance with the wiring diagram.

The safety device works.

aConsult your dealer, or your nearest Panasonic Service Center.

CQ-VX220W

41

Image 41
Contents Model CQ-VX220W Observe the following warnings when installing Observe the following warnings when using this unitObserve the following cautions when installing Observe the following cautions when using this unitSafety Information Components Before Reading These InstructionsFeatures Contents Radio radio settings a Disc disc settings aPreparation AV1/AV2 Camcorder, VCR, etcBefore Initial Use Battery ReplacementPictographs Disc MarksName of Controls and Functions + VOL RET ReturnSRC PWR RETTouch Panel Operation Overview Audio Source Example CD modeVideo Source Operation ScreenGeneral PowerGeneral Operations Display Open/CloseTilt Angle VolumeFolding Down Display TemporarilyBefore Disc Playback Because a disc is already loaded When a disc is in the playerVCD Video CD DivX Disc PlayerBasic Operations Chapter/title Chapter/title SelectionFrom a specific Useful Function DivX CommonDisplayed items Displayable charactersSupported file systems Copyright No warrantyMaximum number of files/folders Compression method Bit rateRadio TuningAuto Preset Memory Preset MemoryPreset Swap Manual Preset MemoryUSB Audio Device Control ¡Connect a USB audio device to USB connector of this unitPreparation IPod/USB on the Source Selection ScreenFile Selection List Folder/File SelectionRandom Play within Current Folder Scan PlayControllable iPod, iPhone/software version USB iPod ControlTitle scroll Operation Buttons Only for Audio mode Mode or audio modeSelection of video Shuffle SongsAudio L Audio R Video Ground ¡Connect an optional external device to the AV1/AV2AV1/AV2 on Remove the Face Plate Install the Face PlateFace Plate Removal Alarm Basic Setting SettingsSound DiscExample setting screen of Display Adjustment a Setup OperationTouch Operation Screen Exit from the menuCamera DisplayOSD Color RGB InputACC Select Bright ContrastColor TintFader BalanceBass TrebleAngle Mark DVD AspectLetter Box Down Mix Auto PresetTouch Touch Disc About DivX VOD ContentDisplay the unit’s registration code ACheck the speaker wiring TroubleshootingPossible cause a Possible solution Picture is dark. ACheck the wiring of the antenna power leadDisplay does not go Back into the unit Picture is whitish. SomethingSound skipping or noise Picture stops No playback or disc Ejected CD-Rs/RWs/DVDDisplay Error Display MessagesNo response to pressing Buttons An unsupported USB device was connected No playable files existFor some reason, an over-current was detected WMA file can be copyrightedIf the Unit Begins to Case you forget the ID Replacing the Fuse CodeMalfunction Product ServicingThinner BeBenzine MaintenanceCleaning this Unit DVD-Rs/RWs Other cases... a Language Code ListCode Language Name Touch To determineInteractive DVD Dolby DigitalLetterbox screen Lpcm Linear PCM audioSpecifications Memorandum 103 YFM264C157CA PTW1208-1029