7. OPERATION
Note:
•Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold).
English
Basic Operation
CAUTION
When this unit is turned on, starting and stop- ping the engine of a car with its volume raised to the maximum level may harm your hearing. Be careful about adjusting the volume.
1)Press the POWER button 5 .
*To turn the power off, press the POWER button for at least 1 second.
2)Press the FNC button 5 to select the oper- ation mode. The mode switches as follows each time the FUNC button is pressed:
Radio ➜ Tape ➜ CD changer ➜ MD changer ➜ Radio
*If a component is not connected, that operation mode cannot be selected.
*“CASS” appears when no tape is loaded in the ARX4570, and “DISC” appears when no disc is loaded in the CD changer and MD changer.
3)Use the Up and Down buttons 3 to adjust the volume.
: Increases the volume.
: Decreases the volume.
Setting the Z-enhancer
This unit comes with three types of sound tone effects stored in memory. Select the one you prefer.
*The factory default setting is
Each time you press
•
•
•
•
Loudness Function
Press the LD button 19 for at least 2 seconds to turn the loudness function on and off.
Switching the Display
While pressing the BND button 18 , press the DISP button 13 to enter the clock display mode. Operation mode display ➜ Clock display ➜ Operation mode display
Audio Mode Adjustments
1)Press the
BASS/TREB ➜ BAL/FAD ➜ Previous mode
2)Use the Left and Right and the Up and Down
buttons 3 , 20 to adjust the bass and treble.
<Adjusting the bass>
: Bass gets stronger.
: Bass gets weaker.
<Adjusting the treble>
: Treble gets stronger.
: Treble gets weaker.
3)Use the Left and Right and the Up and Down
buttons 3 , 20 to adjust the balance and fader.
<Adjusting the balance>
: Sound from right speakers gets stronger.
: Sound from left speakers gets stronger.
<Adjusting the fader>
: Sound from front speakers gets stronger.
: Sound from rear speakers gets stronger.
Setting the Clock
1)While pressing the BND button 18 , press the DISP button 13 to enter the
clock display mode.
2)While pressing the BND button 18 , press the DISP button 13 for 2 seconds
or more. This enables clock editing.
*The editable fields will be indicated by flash.
3)To move between the hour and minute fields, use the Left (hour) and Right (minute) buttons 20 .
4)To confirm the clock setting, press the BND button 18 .
Notes:
•If you select another operation mode before complet- ing the above procedure, the clock setting operation will be canceled.
•Removing the battery for a check or repair causes the clock to be reset. Set the clock again in such a case.
8