Sharp HT-DD5000 operation manual Preset tuning, Preset memory scan

(Continued)
2	3	4

■Preset tuning

You can store up to 40 stations in memory (40 stations con- sisting of any combination of FM and AM stations you like) and recall them at the push of a button.

To enter stations into memory:

1 Perform steps 1 - 6 in the "Tuning" section.

2 Press the MEMORY button.

●"MEMORY" will flash.

3 Within 5 seconds, turn the jog dial to make the preset channel number flash in the display.

●Store the stations in memory, in order, starting with preset channel 1.

4 Within 5 seconds, press the ENTER button to store that station in the selected station preset number memory.

●If the "MEMORY" and preset number indicators go out before the station is memorized, repeat the operation from step 2.

5 Repeat steps 1 - 4 to set other preset stations, or to change a preset station.

To recall a memorized station:

Turn the jog dial on the main unit or press the PRESET (X or W) button on the remote control for less than 0.5 seconds to select the desired station.

●The stations (preset channel number, frequency and fre- quency band) which have been stored in memory will appear in the display in numerical order, irrespective of the frequency bands.

XPRESET W

Note:

When searching for a memorized station, do not press the PRESET button for more than 0,5 seconds.

When the PRESET button is pressed for more than 0,5 sec- onds, the unit will enter the preset memory scan mode.

Backup function:

The backup function protects all station presets for a few hours should there be a power failure or the AC power cord is removed from the AC outlet.

■Preset memory scan

The stations saved in the preset memory can be scanned auto- matically.

1 To scan the preset stations, press the PRESET (X or W) button for more than 0,5 seconds.

●The station preset number will flash and the programmed sta- tions will be tuned in sequentially, for 5 seconds each.

2 Press the PRESET (X or W) button again to stop the mem- ory scan at the desired station.

Note:

When the preset memory does not have any stations stored in it, the preset memory scan will not function.

To erase the contents in the preset memory:

1 Select the preset channel number you want to erase. 2 Hold down the MEMORY button until "CLR" appears.

3 Within 5 seconds, press the ENTER button.

●After performing this operation, the preset memory informa- tion will be erased.

22

HT-DD5000(SEC) TINSE0009SJZZ