Cadence M7000 manual HOW to Trouble Shoot a System, General

Page 12

HOW TO TROUBLE SHOOT A SYSTEM

GENERAL

A car stereo system consists of many different pieces of equipment connected together, and a logical process of elimination will find the problem area, by isolating sections, and checking them one at a time. Before following the instructions below, check and double check all wiring and connections.

TOOLS NEEDED

The following tools will help in finding problems:

A general purpose multi meter, capable of checking voltage and resistance, is perhaps the most useful piece of test gear that any installer can own.

You may also need a test speaker, and a head unit, as these will be handy for temporary connection for checking purposes when you are working in the trunk of the vehicle.

NO SOUND

This is probably the most perplexing problem to find.

1.Reduce the amp gain to 9 volts and unplug the RCA cables and speakers from the amplifier.

2.Check with your multi meter that each amplifier in the system has proper 12 volt DC supply on it is power terminals.

3.Also check that the remote turn on terminal has 12 volt on it.

If all seems well, and the amplifier power indicators lights without any diagnostic light:

4.Connect the head unit RCA directly to the amplifier (eliminating any signal processors which you may have installed in between the head unit and amplifier) and turn on the system.

If the power LED is on with no Diagnostic LED, continue:

5.Connect each speaker one at a time to see which speaker puts the amp in diagnostic.

By utilizing this process of elimination you can determine where the cause of the problem is. If the amplifier goes in to diagnostic with nothing connected to it, and you are sure of proper power and ground, please contact our service department for further help a 732 370 5400

10

Image 12
Contents M7000 Table of Contents Page Power and Protection Circuitry Nickel Plated TerminalsMute Circuit Arva Automatic Rail Voltage Adjustment Circuitry Battery VoltageBass Drive Equalization Circuitry ADR -ACTIVE Dynamic RegulationInstallation Basics POWER/GROUND Wiring Setting the Controls Remote Turn on ConnectionAdjusting the System Woofer Ohm Power when two M7000「are strapped together is 2000 Watts HOW to Trouble Shoot a System GeneralAmplifier Overheating and Shutting Down M7000 Parallel Single Voice Coil Speakers Series Dual Voice Parallel Coil Speakers Dual Voice Coil