Avocent DA1200P manual Troubleshooting, Regulatory Compliance

Page 7

6.0TROUBLESHOOTING

Problems with the DA1200P amplifier are rare. Most of the time, the problem is caused by the use of an incorrect cable for the signal type, to long a cable run, bad connectors on the cable and occasionally damaged cables. Bad grounds or use of different AC power sources for the DA1200P amplifier, source and/or display device(s) may also cause problems due to ground loops.

After trying the above suggestions should the problem still persist, contact your dealer for additional suggestions before contacting Avocent. Should the dealer’s technical personnel be unable to assist you, contact Avocent via our support website: http://support.avocent.com. Create a technical support request on the site and our support team will respond within a short period of time.

7.0REGULATORY COMPLIANCE

European ‘CE’ Mark Statement

Emissions: EN 55022:1998+A1:2000+A2:2003 ( Information technology equipment. Radio disturbance characteristics. Limits and methods of measurement)

EN 61000-3-2:2000+A1:2001+A2:2005 (Limits for Harmonic Currents Emissions) EN 61000-3-3:2000+A1:2001+A2:2005 (Limitation of voltage fluctuations and flicker in low-voltagte supply systems)

Immunity: EN55024:1998+A1:2001+A2:2003 (Information technology equipment. Immunity characteristics. Limits and methods of measurement)

FCC Statement

Class A Device: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide a reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the Instruction Manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Caution: This equipment is intended for use in the manner prescribed in the Instruction Manual. Any user changes or modifications not expressly approved by Avocent Corporation could void the user’s authority to operate the equipment.

7

Image 7
Contents Emerge DA1200P 1x2 PC/VGA Distribution Amplifier Page Introduction Features General Function DA1200P SpecificationsConnecting the Hardware Checking Package ContentsCascading Operating the UnitRegulatory Compliance TroubleshootingContact Information Where AV and IT Meet