TOP PANEL CONTROLS
1.Input Gain Adjustment - Controls amplifier sensitivity and is used to match the input level of the ampli- fier to the output level of the signal source.
2.Crossover Selection Switch - Controls the type of filter for the on- board active crossovers. FLAT does not attenuate any frequencies and is for
FIGURE 4—AMPLIFIER CONTROLS TOP
tweeters. LPF attenuates high frequencies and is typically used for subwoofers.
3.Crossover Frequency Adjustment - Adjusts the crossover point for the on board active crossovers.
4.Bass EQ Switch - Adds an additional 8 db of boost to the speaker output when on.
2
1
3
4
10 | © 2002 Directed Electronics, Inc |
|