2.00” (5.08 cm)
11.00” (27.94 cm)
8.63” (21.92 cm)
.31” | 1.82” typ. |
(7.8 mm) | (4.62 cm) |
ø.31” x 4 (7.8 mm)
2.75” (6.98 cm)
31” typ. (7.8 mm
Figure 3
Mounting Bracket Hole Layout (not to scale)
Note that using a MM4 Mobile Mount assembly in the horizontal configuration requires leaving a minimum access for printer controls from any overhanging horizontal surface. (Refer to Figure 2).
CAUTION: Do not use the circular cutouts in the Mounting Bracket as the only mounting point when using in the horizontal configuration.
Hardware to secure the Mobile Mont to the vehicle is not supplied in the kit. Recommended fasteners are 1/4” (6 mm) diameter hex head or socket head bolts with flat washers, lock washers, nuts and/or locking nuts.
P1005089 Rev. C | pg. 7 of 13 |