Nextar NC990C manual Maintenance of Remote Controller, Battery Information, Wiring Diagram

Page 10

MAINTENANCE OF REMOTE CONTROLLER

Before using the remote control, pull out the insulating patch. This patch was installed to insulate the battery from draining until ready to use.

BATTERY INFORMATION:

Lithium Battery: CR2025 3V

Battery Life: Approximately 6 months.

Replacing the Battery from the Remote Controller:

1)Remove the battery holder by pressing the locking tab with your thumb and pulling it out.

2)Replace the battery with the same type and the “ + ”side facing up.

3)Gently push in the holder until securely locked into place.

B

A

+ side up

WARNING:

Do not recharge, disassemble or dispose of in fire.

Battery leakage may cause damage to the unit.

To avoid the risk of accident, keep batteries out of reach of children.

WIRING DIAGRAM

 

BLUE AUTO ANT

-

-

-

-

Note:

1.Make sure use a speaker with 4 ohm load impedance.

2.Do not make the auto antenna wire and ground touch each other.

E 9

Image 10
Contents RDM LOU Dear Customer About this ManualSEL Audio Mode SELECT/ROTARY Encoder Location and Function of ControlsFader Control Beep 2ND, Beep ALL, Beep OFF ModeVOL LAST/VOL ADJ AUTO-STORAGE/PRESET Memory Scan Button Loudness Button Power ButtonBand Button LOCAL/DISTANCE ButtonMode Button Release ButtonClock Button Infrared Remote Control Sensor Eject ButtonReset Button Scan ButtonDisc Maintenance Precautions and MaintenanceBattery Information Maintenance of Remote ControllerWiring Diagram Installation Method Trouble Shooting PlaySpecification