Knoll Systems MVP44a installation manual Limited Warranty, Version

Page 1

Specifications

MVP44a 8 Channel Power Amplifier

Inputs:

4 pairs of gold RCA jacks

Input impedance:

24 k ohms

Outputs:

Gold 5 way Binding posts

Output power:

50 watts RMS per channel (8 ohms)

Peak output power: 100 watts RMS per channel (8 ohms)

Ideal impedance:

6-8 ohms

Freq. response:

10 Hz - 40 kHz +/- 1 dB (1w)

S/N ratio:

over 105 dB A weighted 50 watts

THD distortion:

<0.1% 20 Hz to 20 kHz

IMD distortion

<0.01% 60 Hz 7 kHz 4:1 (SMPTE)

Trigger control:

12VDC output 60mA max.

Power:

750 watts 117 VAC

Dimensions:

17" x 3.5" x 10.5"

Weight:

22 lbs (10 kg)

Operating Temp:

-20C to +60C (-4F to +140F)

Caution: Never listen to sound that is distorted. If distorted sound is heard, turn the volume down immediately or speaker

and/or amplifier damage could occur that is not covered by the warranty. If this problem persists, contact your dealer.

Limited Warranty

Knöll Systems warrants the its electronic products except projectors sold in Canada and the USA by authorized Knöll dealers to be free from defects in materials and workmanship. This warranty extends for three full years from the date of purchase by the consumer. Any products returned freight prepaid to Knöll Systems and found to be defective by Knöll Systems within the warranty period will be repaired or replaced at Knöll Systems option, at no charge. Knöll Systems will not be responsible for the actual cost of installation or removal of the product, nor for any consequential or incidental damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights. You may have additional rights which vary from state to state. Knöll products sold outside of Canada and the USA may be covered by warranties provided by an authorized Knöll distributor. Please contact the distributor in the country that the Knöll product was purchased.

Printed in Canada

Knöll Systems, Richmond, BC & Point Roberts WA

CCOPYRIGHT 1998-2003, Knöll Systems, All Rights Reserved

Knöll Systems

In America:

In Canada:

tel (604) 272-4555

145 Tyee Drive, #1206

11791 Machrina Way #120

fax (604) 272-5595

Point Roberts, WA 98281

Richmond, B.C. V7A 4V3

systems

MVP44a

Four stereo power amplifiers with individual volume control electronics and four input source selection

INSTALLATION

MANUAL

It is very important to use a top quality

RJ45 8/8 crimper tool. We strongly

suggest using a cat 5 / RJ45 electronic tester to verify the wire conductors.

Complies with part 15 of the FCC rules. Operation is subject to:

1.This device may not cause harmful interference

2.This device must accept any interference received including interference that may cause undesired operation.

Version 3.3

Image 1
Contents Specifications MVP44a 8 Channel Power Amplifier Limited WarrantyVersion Troubleshooting Key FeaturesNever connect the MVP44a to 2 ohm loads System layout considerationsPage Single IR Command Storing InstallationSequence IR Command Storing MVP44a Activation Power OnProgramming Wiring the 590-00 to the MVP44a See the diagram onMVP44a to Xantech MR60 keypad functions RJ45 plug color and pair wiring guideRJ45 plug function identification