7.Install MR60 keypads (or infrared receivers) in the rooms with the speakers. Cat 3 or cat 5 wire can be home run to the MVP44a or up to three rooms daisy chained on one wire.
***Be sure to set the dip switch on the rear of the MR60*** See the dip switch adjustment below. Connect all eight individual wires using RJ45 connectors. Four wire conductors are needed for each keypad (one unique, common: IR , ground and 12VDC).
MVP44a Activation
The
MR60 Dip Switch
Adjustment
Use either RJ45 connector as they are in parallel
MR60 1 2 3 4
Some examples to understand when MVP44a pulses are activated and the
Pulse O/P | Activates when: | Example IR sequence: |
The rear of the MR60 is shown. Because one to three MR60's can be connected or daisy chained to the same cat 5 wire, the keypad position on the wire must be selected using the dip switch. The two MR60 RJ45 connectors are in parallel. Only one dip switch slider should be on and the other two off (#1 is shown on in this example). The MR60
***Even if the keypads are home run, the MR60 dip switch position has to be selected***
If three keypads are daisy chained on one wire, select the MR60 dip switch on the first MR60 to one, the second MR60 to two and the third MR60 to three. At the rear of the MVP44a, the RJ45 connector from the three MR60 keypads can be connected any corresponding keypad Bank A3 or Bank B; port 1, 2 or 3. The corresponding speaker outputs will be the same number as selected
Power On | Any MR60 or RB8 source |
(TON) | key is pushed when all |
F A | MR60 leds are off. |
FNC then Source A (CD) | |
(source A | key pushed when system's on |
CD player) | and no MR60 blinking led's. |
F B | FNC then Source B (FM or |
(source B | AUX1) key pushed when |
Jazz station) | the system is on. |
F C | FNC then Source C (Dish |
(source C | AM or CD2) key pushed |
news tuner) | when the system is on. |
F D | FNC then Source D (AUX or |
(source D | AUX2) key pushed when |
sat dish#2) | the system is on. |
Sequence power (on) command to all source components CD skip, CD play or CD random
CD skip to next disk
Scan to next news station programmed into news tuner Scan up one station
on the MR60 keypad (example: the MR60 keypad with #2 dip on and connected to MVP44a keypad bank B will control speaker outputs B2R and B2L).
After installation, if the keypads are not working properly or not controlling at all, Check the MR60 dip switch settings, wiring layout and crimp as well as bank connections very carefully.
6
Programming the 590-00
IR functions do not have to be related to the source input. For example, if source A is a CD player and source B is a jazz tuner, function A could be a sequence of CD skip, CD play, and CD random. Function B could be CD Skip to next disk. After deciding and writing down the commands to be programmed for each of the six pulse activations (Function A, B, C, D, TON and TOFF),
11