Magnavox 46ME313V/F7 A, 50ME313V/F7 A owner manual Useful tips

33 .English

7 Useful tips

FAQ

Question

Answer

●

Check the Antenna or Cable Connection to the Main Unit.

●

Check the Batteries on the Remote Control.

●

Re-insert the Batteries with their Polarities (+/–) as indicated.

My Remote Control does

●

Check if there is an obstacle between the infrared sensor window and the Remote Control.

●

Test the IR Signal Output use IR Signal Check. L p. 35

not work.

If okay, then possible Infrared Sensor trouble.

What should I do?

●

Aim the Remote Control directly at the infrared sensor window on the front of the Unit.

●

Reduce the distance to the Unit.

●

When there is an infrared-equipped device such as PC near this Unit, it may interrupt the Remote Control signal on this

Unit. Move the infrared-equipped device away from this Unit, change the angle of the Device's infrared sensor or Turn

Off the infrared communication function.

How come the Initial Setup

●

Connect the RF Coaxial Cable directly to this Unit and run the Initial Setup.

appears every time I Turn

Make sure to complete the Initial Setup before the Unit goes into Standby mode.

On this Unit?

●

●

Autoprogram must be completed when you Set Up the Unit for the First time or Move it to a location where previously

unavailable channels are broadcast.

●

Make sure Autoprogram has been completed. L p. 23

Why can I not watch some

●

The selected channel may not be broadcasting.

●

When Autoprogram is interrupted and not completed, some channels will not be received. Make sure to complete the

RF signal TV Programs?

Autoprogram. L p. 23

●

The selected channel cannot be viewed by the Child and Ratings Lock setting. L p. 26

●

The Unit requires some kind of Antenna Input. An indoor Antenna (Digital or VHF / UHF), an External Antenna (Digital

or VHF / UHF) or an RF Coaxial Cable from your wall Cable / Satellite Set-top Box needs to be plugged into the Unit.

●

Check if the correct Input mode is selected by pressing

SOURCE

or using

CH + / –

. Refer to

Watching Channels from

How come there is no

an External Device

. L p. 17

image from the Connected

●

Check the Antenna, Cable or other Input Connection to the Unit.

External Devices?

●

When using the Component Video Connection check that the Green (Y), Blue (Pb/Cb) and Red (Pr/Cr) connectors

are connected to their corresponding colored jacks on the Unit.

When I enter a channel

●

Many Digital channels have alternate channel numbers. The Unit changes the numbers Automatically to the ones signifying

number, why does it change

the Broadcasting Station's channel number. These basic numbers used for the previous Analog Broadcasts. (e.g., Input

Automatically?

Digital ch# 30 Automatically changes to Digital ch# 8.1)

Why are captions not

●

Closed Captions that are delayed a few seconds behind the actual dialog are common for Live broadcasts. Most captioning

displayed Entirely?

production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selective

Or why are captions

editing is used to insure that the Closed Captions remain up-to date with the current TV screen dialog.

delayed behind the dialog?

How can I set the clock?

●

There is No clock function on this Unit.

My PIN code no longer

●

If a Power failure occurs for longer than 10 seconds the child lock setting is retained, but the PIN code is reset to the

works, how can I change the

default code 0000. Refer to

Child and Ratings Lock

. L p. 26

Child Lock setting?

Continued on next page.