Wall Plate Installation
AB
C
There are four pieces that will need to be interconnected in order for the
First, remove the face plate from the HDBaseT module. To do this, remove the four 4mm screws on the sides (as pictured above).
Note: Avoid contact with the PCB board (see picture B) in the HDBaseT module, electrostatic discharge (ESD) may damage sensitive chips.
Next, route the CAT cable through the electrical box (as seen above) and connect it to the back of the HDBaseT module (see picture on top of page 6).
atlona.com | 5 | Toll free: |
Local: | ||
|
|