Installation
Note:
• | Before finally installing the unit, connect the |
| wiring temporarily, making sure it is all connected |
| up properly, and the unit and the system work |
| properly. |
• | Use only the parts included with the unit to ensure |
•If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. (Fig. 6)
2. Install side brackets. (Fig. 8)
7When the installation space is not very deep
When installing in a shallow space, secure with side brackets (small). In this case, stick con- ceal tape on parts that protrude from the dashboard.
<ENGLISH>
DIN Rear-mount
Installation using the screw holes on the side of the unit
proper installation. The use of unauthorized parts |
can cause malfunctions. |
• Consult with your nearest dealer if installation |
requires the drilling of holes or other modifications |
of the vehicle. |
• Install the unit where it does not get in the driver’s |
way and cannot injure the passenger if there is a |
sudden stop, like an emergency stop. |
• Do not place the display in a position where it will |
impede the driver’s visibility or affect the opera- |
tion of your vehicle’s air bags. |
• The semiconductor laser will be damaged if it |
overheats, so don’t install the unit anywhere hot |
— for instance, near a heater outlet. |
30°
Fig. 6
Side bracket
Flush surface screw (5 ⋅ 6 mm)
Fig. 8
3. Fastening the unit. (Fig. 9) |
As a rule, secure with side brackets (large). |
Dashboard
182
53
Holder
After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Conceal tape
1. Remove the frame. (Fig. 11)
Frame
Pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Holder
Attach screw
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
DIN Front-mount
Installation with the rubber bush
1. Remove the frame. (Fig. 7)
Frame
Pull out to remove the frame.
Dashboard
182
53
Side bracket (large)
After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Attach screw
Side bracket (small)
Fig. 10
Fig. 11
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 9
Fig. 7