Pioneer AVX-P7300DVD installation manual Connecting the Units, ACC position No ACC position

Connecting the Units

Note:

• This unit is for vehicles with a 12-volt battery and

negative grounding. Before installing it in a recre-

ational vehicle, truck, or bus, check the battery

voltage.

• To avoid shorts in the electrical system, be sure to

disconnect the ≠ battery cable before beginning

installation.

• To prevent incorrect connection, the input side of

the IP-BUS connector is blue, and the output side

is black. Connect the connectors of the same

colors correctly.

• If this unit is installed in a vehicle that does not

have an ACC (accessory) position on the ignition

switch, the red lead of the unit should be connected

When Connecting the Multi-Channel AV Master Unit

Multi-Channel AV	RGB cable
Master Unit (e.g. AVM-P9000R)	(supplied with the Multi-
(sold separately)	Channel AV Master Unit)

<ENGLISH>

Connection box (supplied with the DVD Navigation Unit)

AVX-P7300DVD

• Refer to the owner’s manual for details on

connecting the power amp and other units, then

make connections correctly.

• Secure the wiring with cable clamps or adhesive

tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch any

to a terminal coupled with ignition switch ON/OFF

operations. If this is not done, the vehicle battery

may be drained when you are away from the vehi-

cle for several hours. (Fig.1)

	CC
F	A	O	F	O
F

Red

Green

Red (Right)

White (Left)

Green

To video output

DVD Navigation Unit (e.g. AVIC-9DVD) (sold separately)

moving parts, such as the gear shift, handbrake and

seat rails. Do not route wiring in places that get

hot, such as near the heater outlet. If the insulation

of the wiring melts or gets torn, there is a danger of

the wiring short-circuiting to the vehicle body.

• Don’t pass the yellow lead through a hole into the

engine compartment to connect to the battery. This

will damage the lead insulation and cause a very

dangerous short.

• Do not shorten any leads. If you do, the protection

circuit may fail to work when it should.

O	N			O	F	N
			S					S
			T					T
	T	R	A				R	A
						T
ACC position				No ACC position

Fig. 1

Yellow

Yellow	Blue
Red	Blue

To audio outputs

RCA cables (sold separately)

Yellow/black

To Yellow/black lead (GUIDE ON) on the navigation unit.

Multi-CD player (sold separately)

Voice guidance speaker (supplied)

3 m

INSTALLATION MANUAL

This product conforms to CEMA cord colors.

Le code de couleur des câbles utilisé pour ce produit est conforme à CEMA.

Printed in Japan

Imprimé au Japon

MANUEL D’INSTALLATION

• Never feed power to other equipment by cutting

the insulation of the power supply lead of the unit

and tapping into the lead. The current capacity of

the lead will be exceeded, causing overheating.

• When replacing fuse, be sure to use only fuse of

the rating prescribed on the fuse holder.

• If the RCA pin jack on the unit will not be used, do

not remove the caps attached to the end of the con-

nector.

•Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the

same function.

FM MODULATOR

IP-BUS MAIN UNIT

IP-BUS AV MASTER

RCA cable (sold separately)

20 pin cable

(supplied with the TV tuner)

IP-BUS cable		Optical cable			Blue	This product
(supplied with the TV tuner)		(supplied with the Multi-
		Channel AV Master Unit)
Black	Blue
					40 cm
Hide-away TV Tuner					Black
(e.g. GEX-P7000TV)
		RCA cable (supplied)
(sold separately)
		6 m			Not used.
			Blue
					40 cm
	Green	IP-BUS cable (supplied with the			Yellow	16 cm
		Multi-Channel AV Master Unit)			(AVM OUTPUT)
Red	AV cable
	(supplied with the
	Multi-Channel AV	Gray	Green	3 m	20 pin cable	Red
Gray	Master Unit)
					(supplied)

<CRD3479-A> UC <KYMFF/01D00000> Fig. 2