Pioneer AVH-P7850DVD DIN Rear-mount, Installation using the screw holes on the side of the unit

Installation

2.Install the unit into the dash- board. (Fig. 14)

After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)

Dashboard

182

53	Rubber bush
	Screw

Holder

Side bracket

Screw (2 ⋅ 3 mm)

•After installing the unit into the dashboard, reattach the frame.

Fig. 14

DIN Rear-mount

Installation using the screw holes on the side of the unit

•Fastening the unit to the factory radio mounting bracket. (Fig. 15) (Fig. 16) (Fig. 17)

Select a position where the screw holes of the bracket and the screw holes of this product become aligned (are fit- ted), and tighten the screws at 2 places on each side. Use any of binding screws (4 ⋅ 3 mm), binding screws (5

⋅6 mm) or flush surface screws (5 ⋅ 6 mm), depending on the shape of the screw holes in the bracket.

*1 Use binding screws (4 ⋅ 3 mm) only.

*1

*1

Fig. 15

•When installing in a shallow space, use the following screw holes. In this case, stick conceal tape on parts that protrude from the dashboard.

Conceal tape

*1

*1

Fig. 16

Screw

Dashboard or Console

Factory radio mounting bracket *2

*2 If the screw holes of the bracket and the screw holes of this unit are not aligned, use a file to widen the screw holes of the bracket to match up the screw holes on this unit. Tighten the screws at 2 places on each side.

Fig. 17

Installing the remote control unit

When not using the remote control unit, secure it with velcro tape to pre- vent it from moving.

•Thoroughly wipe off the surface before affixing the velcro tape.

Remote control unit

Velcro tape (small) (hard)

Velcro tape (small) (soft)

Fig. 18

English Español Deutsch Français Italiano Nederlands PyÒÒÍËÈ

17 18