Pioneer AVH-P7850DVD installation manual Connecting the Units, Contents

Page 2

Contents

 

Connecting the Units

2

Connecting the system

3

Connecting the power cord (1)

5

Connecting the power cord (2)

7

When connecting to separately sold power

 

amp

9

When connecting with a rear view camera

.... 11

When connecting the external video

 

component and the display

13

Installation

15

Installing the hide-away unit

15

DIN Front/Rear-mount

16

DIN Front-mount

16

DIN Rear-mount

17

Fixing the front panel

18

Installing the remote control unit

18

WARNING:

To avoid the risk of accident and the potential violation of applicable laws, the front DVD or TV (sold separately) feature should never be used while the vehicle is being driven. Also, Rear Displays should not be in a location where it is a visible distraction to the driver.

In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit’s DVD features should not be used.

TEXT 001 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxx.

CAUTION:

PIONEER does not recommend that you install or service your display your- self. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to autho- rized Pioneer service personnel.

Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.

Do not drill a hole into the engine com- partment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insu- lation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point.

It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving.

Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat slid- ing mechanism.

Do not shorten any leads. If you do, the protection circuit may fail to work properly.

Connecting the Units

Note:

This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recre- ational vehicle, truck, or bus, check the battery voltage.

To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation.

Refer to the owner’s manual for details on connecting the power amp and other units, then make connections correctly.

Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts.

Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insu- lation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body.

Don’t pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short.

Do not shorten any leads. If you do, the protection circuit may fail to work when it should.

Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.

When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse holder.

Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right speaker leads are common.

If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector.

Speakers connected to this unit must be high- power with minimum rating of 50 W and imped- ance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged.

When this product’s source is switched ON, a control signal is output through the blue/white lead. Connect to an external power amp’s system remote control or the car’s Auto-antenna relay control terminal (max. 300 mA 12 V DC). If the car features a glass antenna, connect to the anten- na booster power supply terminal.

When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp’s power terminal. Likewise, do not connect the blue/white lead to the power ter- minal of the auto-antenna. Such connection could cause excessive current drain and malfunction.

To avoid a short-circuit, cover the disconnected lead with insulating tape. Insulate the unused speaker leads without fail. There is a possibility of a short-circuit if the leads are not insulated.

To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side is black. Connect the connectors of the same col- ors correctly.

This unit cannot be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch. (Fig. 1)

 

 

CC

 

 

 

 

 

 

 

 

 

F

A

O

 

 

 

F

O

 

 

 

F

 

N

 

N

O

 

 

 

 

O

F

 

 

 

 

 

 

 

S

 

 

 

S

 

 

 

 

 

 

 

 

 

 

 

 

 

 

T

 

 

 

 

T

 

 

 

T

R

A

 

 

 

R

A

 

 

 

 

 

 

T

 

ACC position

No ACC position

Fig. 1

The black lead is ground. Please ground this lead separately from the ground of high-current prod- ucts such as power amps.

If you ground the products together and the ground becomes detached, there is a risk of dam- age to the products or fire.

Cords for this product and those for other prod- ucts may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied manuals of both products and connect cords that have the

same function.

English Español Deutsch Français Italiano Nederlands PyÒÒÍËÈ

1

2

Image 2
Contents Installation Manual Deutsch Français Italiano Nederlands PyÒÒÍËÈConnecting the Units ContentsFrançais Italiano Connecting the systemEnglish Español Deutsch Français Connecting the power cordEspañol Deutsch Italiano Nederlands PyÒÒÍËÈNederlands Switch ItalianoDeutsch When connecting to separately sold power amp LeftWhen connecting with a rear view camera When connecting the external video component and the display When using a display connected to rear video outputDIN Front-mount Installing the hide-away unitDIN Front/Rear-mount DIN Rear-mount Installation using the screw holes on the side of the unitInstalling the remote control unit Pioneer Corporation

AVH-P7850DVD specifications

The Pioneer AVH-P7850DVD is a versatile in-dash multimedia receiver designed to elevate the in-car entertainment experience. Aimed at audiophiles and casual listeners alike, this unit combines high-quality audio playback with robust video functionality, making it a popular choice for car enthusiasts.

One of the standout features of the AVH-P7850DVD is its vibrant 7-inch touchscreen display, which allows for easy navigation through menus and settings. The display's high resolution ensures that videos played from DVDs are clear and sharp, making for an enjoyable viewing experience. Additionally, the monitor is motorized, which not only adds a level of sophistication but also conveniently folds away when not in use.

The AVH-P7850DVD supports multiple video formats, including DVD, CD, MP3, WMA, and JPEG, allowing users to enjoy a wide variety of media. Beyond physical discs, it has ample connectivity options, including USB and auxiliary inputs, encouraging users to connect their portable devices or flash drives effortlessly.

For those who prioritize sound quality, the Pioneer AVH-P7850DVD has a powerful built-in amplifier that delivers excellent audio clarity. It features a 5-band graphic equalizer, allowing users to fine-tune their sound preferences with precision. Additionally, the unit includes support for multiple audio formats and offers compatibility with high-resolution audio files, ensuring that every note is reproduced faithfully.

An exciting aspect of this receiver is its built-in support for Bluetooth connectivity, enabling hands-free calling and audio streaming from compatible smartphones. This feature provides a seamless and safe way to take calls while driving, enhancing convenience without compromising safety.

Moreover, the AVH-P7850DVD is compatible with Pioneer's AppRadio technology, allowing users to mirror their smartphone’s interface on the receiver's screen. This integration opens up a wealth of apps specifically designed for in-car use, further expanding the entertainment options available.

With its combination of audio and video capabilities, the Pioneer AVH-P7850DVD sets a high standard for in-dash multimedia receivers. Its focus on quality sound reproduction, user-friendly interface, and extensive connectivity makes it a reliable choice for anyone who spends considerable time on the road.