Pioneer AVH-P6850DVD operation manual Selecting a cross-over frequency

Section

17 Digital Signal Processor

FRONT-L (front speaker left)—CENTER (center speaker)—FRONT-R (front speaker right)— REAR-R (rear speaker right)—REAR-L (rear speaker left)—SUB WOOFER (subwoofer)

#You cannot select speakers whose size is set to OFF at the SPEAKER SETTING menu.

3Touch c or d to adjust the speaker out- put level.

Each time you touch cor d increases or de- creases the speaker output level. +10 to –10 is displayed as the level is increased or de- creased.

Note

To adjust the speaker output levels in this mode is the same as making the speaker output levels at TEST TONE. Both provide the same results.

Selecting a cross-over frequency

You can select a frequency, under which sounds are reproduced through the subwoo- fer. If the installed speakers include one whose size has been set to SMALL, you can select a frequency, under which sounds are repro- duced through a LARGE speaker or subwoo- fer.

1Touch CROSS OVER on the DSP function menu.

2Touch c or d to select the speaker to be adjusted.

Each time you touch cor d selects the speak- er in the following order:

FRONT (front speakers)—CENTER (center speaker)—REAR (rear speakers)—

SUB WOOFER (subwoofer)

80 En

Black plate (80,1)

3Touch c or d to select cross-over fre- quency.

Each time you touch cor d selects cut-off fre- quencies in the following order:

63—80—100—125—160—200 (Hz)

Note

Selecting a cross-over frequency is to set a cross- over frequency of the subwoofer’s L.P.F. (low-pass filter) and that of the SMALL speaker H.P.F. (high- pass filter). The cross-over frequency setting has no effect if the subwoofer is set to OFF and other speakers are set to LARGE or OFF.

Adjusting the speaker output levels using a test tone

This function allows you to easily get the over- all balance right among the speakers.

1Touch TEST TONE on the DSP function menu.

2Touch START to start the test tone out- put.

The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about two seconds. The current settings for the speaker over which you hear the test tone are shown in the display. FRONT-L (front speaker left)—CENTER (center speaker)—FRONT-R (front speaker right)— REAR-R (rear speaker right)—REAR-L (rear speaker left)—SUB WOOFER (subwoofer) Check each speaker output level. If no adjust- ments are needed, perform step 5 to stop the test tone.

# The settings do not appear for speakers whose size is set OFF.

<CRB2163-B>80