Cisco Systems AIR-ANT5170P-R specifications System Requirements, Safety Precautions

Page 3

System Requirements

System Requirements

This antenna is designed for use with Cisco Aironet access points and bridges but can be used with any 5-GHz Cisco Aironet radio device that uses an RP-TNC connector.

Safety Precautions

Warning Installation of this antenna near power lines is dangerous. For your safety, follow the installation directions.

Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents.

Warning In order to comply with international radio frequency (RF) exposure limits, dish antennas should be located at a minimum of 8.7 inches (22 cm) or more from the bodies of all persons. Other antennas should be located a minimum of 7.9 inches (20 cm) or more from the bodies of all persons.

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.

Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available.

Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, as they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70, National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).

Each year hundreds of people are killed or injured when attempting to install an antenna. In many of these cases, the victim was aware of the danger of electrocution, but did not take adequate steps to avoid the hazard.

For your safety, and to help you achieve a good installation, please read and follow these safety precautions. They may save your life!

1.If you are installing an antenna for the first time, for your own safety as well as others, seek professional assistance. Your Cisco sales representative can explain which mounting method to use for the size and type antenna you are about to install.

2.Select your installation site with safety, as well as performance in mind. Remember: electric power lines and phone lines look alike. For your safety, assume that any overhead line can kill you.

Cisco Aironet 7-dBi Diversity Patch Antenna (AIR-ANT5170P-R)

 

78-16468-02

3

 

 

 

Image 3
Contents Cisco Aironet 7-dBi Diversity Patch Antenna AIR-ANT5170P-R Technical Specifications System Requirements Safety PrecautionsInstallation Guidelines Installing the Antenna Site SelectionTools and Equipment Required Antenna Cable Information Mounting on a Vertical SurfaceObtaining Documentation Grounding the AntennaCisco.com Ordering Documentation Documentation FeedbackCisco Product Security Overview Documentation DVDReporting Security Problems in Cisco Products Obtaining Technical AssistanceCisco Technical Support Website Definitions of Service Request Severity Submitting a Service RequestObtaining Additional Publications and Information Obtaining Additional Publications and Information