BenQ DV3750 user manual Using the Remote Control, Batteries

Page 20

English

Using the Remote Control

When using the remote control, aim it at the remote control sensor window on the display. If there is an object between the remote control and the signal remote control sensor window on the display, the remote may not operate.

When using the remote control, please note:

Do not strike or drop the remote. Do not expose the remote control to liquids and do not place it in humid environments.

Do not install or place the remote control in direct sunlight. The heat may damage the remote control.

If the remote control sensor window on the display is in direct sunlight or strong light, the remote control may not operate normally. In this situation, change the light source or readjust the angle of your display, or operate the remote control from a location closer to the remote control sensor window on the display.

Batteries

You will need to install the supplied batteries into the remote control to make it operate following the instructions below.

1. Open the lid of the remote control battery compartment.

2. Insert two size-AAA batteries (included).

Ensure that the batteries are inserted with the positive and negative terminals in the correct direction corresponding to the

(+) and (-) marks in the battery compartment.

3. Install the lid of the remote control battery compartment.

Notes on Using Batteries

The use of the wrong type of batteries may cause chemical leaks and/or explosion. Please note the following:

Always ensure that the batteries are inserted with the positive and negative terminals in the correct direction as shown in the battery compartment.

Different types of batteries have different characteristics. Do not mix different types.

Do not mix old and new batteries. Mixing old and new batteries will shorten battery life and/or cause chemical leaks from the old batteries.

When batteries fail to function, replace them immediately.

Chemicals which leak from batteries may cause skin irritation. If any chemical matter seeps out of the batteries, wipe it up immediately using a dry cloth.

Due to varying storage conditions, the battery life for the batteries included with your display may be shortened. If the remote control is not used for a long period of time, remove the batteries.

14 Remote Control

Downloaded From TV-Manual.com Manuals

Image 20
Contents Welcome Disclaimer Important Safety InstructionsCopyright English Important Information Table of Contents Troubleshooting Specifications Supported Modes Dimensional DrawingsFeature Menu TV Menu Performing Manual Installation Enabling/Disabling Child Lock Changing Password PC MenuFunctions and Features IntroductionPackage Contents Lights up red when the display is in standby mode Standby modeGetting Started with Your Display Main Unit Front ViewChannel VolumeTerminal Panel Main Unit Rear View Connecting Audio and Video Signal Sources Setting up Your DisplayConnecting the Antenna Connecting Composite AV Video Signal Scart Connecting Composite AV Video Signal RCAConnecting S-Video Signals EquivalentConnecting RGB Signals Mini D-SUB Connecting DVI SignalsConnecting the Power Cord Connecting Audio Output SignalsInitial Setup Or VolumeChannel button on the display to go to the next step Display to select a TV broadcast standardRemote Control Teletext PIP/PBPFreeze Screen aspect ratioUsing the Remote Control BatteriesUsing the Remote Control Power on, Power off and StandbySwitching Inputs Adjusting VolumeSelecting a Picture Mode Using the Freeze FunctionAdjusting Aspect Ratio Buttons to sequentially change channelsUsing the Sleep Timer Adjusting BacklightUsing the Teletext Function Display InformationOn-Screen Display OSD Menu OSD StructureVolume Adjust volume level Use To increase or to decrease Navigating the OSD MenuAudio Menu Then press OK to enter the submenuAdjust left or right speaker Balance Volume level Remote control or the VolumeUse Buttons on Auto, Mono Remote control or the Volume Effect Volume buttons on the display to SurroundPicture Menu Picture Mode Settings Selecting a Picture ModeFeature Menu Video signal. When TV signal in the centerAspect Adjust image aspect Remote control or Ratio e.g. DVD signal, noRemote control or the Volume Nederlands OSD menu TV MenuPress OK to enter the submenu EnglishNaming a Channel Performing Manual InstallationEditing Channels Child Lock Swapping ChannelsDeleting a Channel Enabling/Disabling Child LockChanging Password PC MenuTroubleshooting Antenna Specifications Signal inputsTV tuner Audio inputDimensional Drawings 720 × 31.47 70.08 28.32 DOS modeSupported Modes Unit mm
Related manuals
Manual 38 pages 28.54 Kb