Headrest Installation

1. Unplug the DIN cable from the monitor.

8-pin main DIN cable

5-pin adapter cable

2. Connect the LCD screen’s 8-pin DIN plug into the 8-pin DIN plug of the headrest.

NOTE: When assembling the cable, match the arrows at each end of the connector.

NOTE: Feed and orient the connector assembly behind the shroud mount in the lower right hand corner. You may have to feed some of the DIN cable up into the headrest to accomplish this positioning.

3. Position the monitor over the mounting shroud and apply even pressure to each corner of the mon- itor until the internal clips lock the monitor in place.

NOTE: Do not press on the LCD screen as this will dam- age the screen.

4.Tape the end of the DIN plug to prevent dam- age to the pins. Then feed this cable from the hol-

low post of the headrest down through the seat back and connect it to the cable from the DVD play- er.

NOTE: Ensure the cable does not entangle or interfere with the seat positioning/adjusting mechanism.

12	© 2004 Directed Electronics, Inc.