3.Mount the doorbell button.
Use either screws or double sided tape to mount the doorbell button.
To mount with screws, remove the back of the case by pushing in the tab on the bottom with a small screwdriver and rotating the blade.
Attach the back of the case to the door jamb or wall. Snap the front of the button back on.
When attaching the doorbell button using the double sided tape, make sure the surface of the door jamb or wall is clean.
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any of the jump- ers on your doorbell.
WARNING: Disconnect chime unit from power source before opening code access door. Close door and replace screw before reconnecting to power.
The doorbell button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the doorbell button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Another wireless doorbell system or other wireless products may cause interference and the system may not function properly. Follow the instructions below for setting a new code.