Samson S63, S83 manual Guided Tour - S63 Rear Panel

Guided Tour - S63 Rear Panel

5 3 4

1

2

POWER

oON

OFF

FUSE

ESUF

120 VOLT 6 AMP

220 VOLT 3.5 AMP

EFFECT RETURNS			EFFECT SENDS	S6 MIXER AMPLIFIER	6 CHANNEL 210 WATT 4 Ω
1	+4dB	2	1	+4dB
	47KΩ
				600Ω
+4dB			+4dB
10KΩ	PRE AMP OUT		600Ω
AMP IN			2

CAUTION	!
RISK OF ELECTRIC SHOCK
DO NOT OPEN	MON OUT

SAMSON TECHNOLOGIES CORP., HICKSVILLE, NEW YORK

TO PREVENT SHOCK,

DO NOT OPEN. NO USER

SERVICABLE PARTS

INSIDE. REFER SERVIC-

ING TO QUALIFIED SERVICE

PERSONNEL. TO PREVENT

FIRE OR SHOCK HAZARD

DO NOT EXPOSE TO RAIN

OR MOISTURE

CAUTION

HEATSINK MAY BE HOT!

DO NOT BLOCK AIRFLOW

OR OVERHEATING MAY

OCCUR

8

SPEAKER OUTPUT

MINIMUM 2 Ω

POWER RATING 120V/60Hz 450 W

SERIAL NUMBER

ASSEMBLED

IN R.O.K.

6

7

9

1:Power switch - As you may have guessed, this is what you use to turn the

S63 on and off. The built-in protection relay circuitry (which mutes the outputs for approximately five seconds after powering on) prevents power-on “thumping,” which can potentially damage connected speakers.

2:Fuse holder - Insert a 6 amp fuse here for 120 volt operation. Insert a 3.5 amp fuse here for 220 volt operation.

3:Effect Returns - These unbalanced inputs allow you to route signal from external devices such as effects processors to the Effects Return section of the S63. Because the S63 is a monophonic system, stereo signals input to the pair of Effects returns 1-2 are automatically mixed to mono. See the “Using the Effects Sends and Returns” section in this manual for more information.

4:Effects Sends - These unbalanced outputs allow you to route signal from each of the two discrete Effects Sends to external devices such as effects processors. Effects Send 1 is pre-fader and pre-EQ, while Effects Send 2 is post-fader and post-EQ. See the “Using the Effects Sends and Returns” section in this manual for more information.

14