Samson S63, S83 manual Guided Tour - S63 Rear Panel

Guided Tour - S63 Rear Panel

5:Amp In - This unbalanced input allows you to connect any external mono- phonic line-level signal directly to the S63 power amplifier. This input is not affected by either the ten-band graphic master equalizer or the S63’s Main Level control. The Amp In jack can optionally also be used as an insert patch point as follows:

•Ring - A preamp output which is affected by both the ten-band graphic master equalizer and the S63’s Main Level control.

•Tip - An amp input which is not affected by either the ten-band graphic master equalizer or the S63’s Main Level control.

For more information about the use of the Amp In jack as an insert patch point, contact Samson Technical Support (516-932-1062) between 9 AM and 5 PM EST.

6:Preamp Out - This unbalanced output provides a monophonic line-level output from the S63 mixer section; it is normally used to connect the unit to an external power amplifier and speakers where additional power is required or where additional amplifier feeds are necessary. This output is not affected by the ten-band graphic master equalizer but it is affected by the S63’s Main Level control.

7:Monitor Out - This unbalanced output provides a monophonic line-level output from Effects Send 1, post-Monitor level control (but unaffected by the Main Level control). It is normally used to connect the unit to an external monitor mixer/amplifier/speaker system so that the performers can receive an onstage monitor mix independent of the house mix. See the “Suggested Setups” section of this manual for more information.

8:Speaker Output - These are the S63’s main outputs; use these unbalanced jacks to connect the S63 to any speakers rated at 4 ohms or greater (that is, 4, 8, or 16 ohms). The lower the ohm rating, the greater the power output. We recommend the use of 4 ohm speakers for long-term usage. The S63 delivers 210 watts of power into 4 ohms at less than 1% THD (Total Harmonic Distortion). In order to ensure correct phase correlation, the tip of the S63 speaker jack should be connected to the “+” (hot) input of your loudspeaker, and the sleeve of the S63 speaker jack should be connected to the “-” (ground) input of your loudspeaker.

9:Heat sink - Make sure this anodized aluminum heat sink is unobstructed when the S63 is powered on. In particular, we recommend that you keep the rear of the rack open in order to release heat. If your rack does not have a removable rear, space should be left open on the front of the rack cabinet, espe- cially immediately above the S63— remember, heat rises!

15