Operation

VM8013

Power

Press the (power) button (1) to turn the unit on. Press and hold the power button again to turn the unit off.

Volume Control

To increase the volume, turn the VOL/SEL/MENU (rotary encoder) (2) clockwise. To decrease the volume, turn the rotary encoder counter- clockwise. When volume is adjusted, the volume level will be shown on the display panel as a number ranging from “0” (lowest) to “40” (highest).

DISP CH/

CAT

DIM

SRC

PTY

BAND

INT

1 2

RPT RDM

3 4

DN UP

5 6

A/V IN

SWC Interface (Optional)

The VM8013 is compatible with PAC (Pacific Accessory Corporation) adapter SWI-PS steering wheel control interface. A 3.5mm female connector (labeled SWC Interface) on the back of the head unit is used to connect to the SWI-PS adapter. When the SWI-PS is installed, the following functions are available:

iPod Menu

NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range.

Source

Press the SRC button (6) repeatedly to scan the various sources. A source is only displayed when accessible (optional equipment required for some sources). Available modes include Radio (FM1, FM2, FM3, AM1, AM2), SAT, DISC, SD, USB, and auxiliary (AUX IN).

External Devices

External peripheral devices, including a game console, camcorder, navigation unit, iPod, Zune, etc. can be connected to the AUX IN connector

(18)on the front of this unit using the 3.5mm A/V Media Cable (included). Select “SOURCE >> AUX IN” to access auxiliary devices. You cannot directly control external devices connected to the AUX IN input.

Audio Mute

Press the (power) button (1) to silence the audio volume. “ ” appears on the display. Press (power) again to restore volume to the previous setting.

1.	Vol +
2.	Vol -
3.	Mute
4.	Seek +
5.	Seek -
6.	SRC (Source)
7.	Band

Audio Menu

Press the VOL/SEL/MENU button (2) to access the audio menu. Press the VOL/SEL/MENU button repeatedly to move through the list of menu options.

NOTE: Audio settings only apply to the current source (Source Tone Memory). You must make audio adjustments for another source when that source is active.

•Sub_w: When the Low Pass Filter is activated (see “Menu Operation” on page 8), you can use the VOL/SEL/MENU rotary encoder to adjust the subwoofer volume from “-14” to “0”.

•BASS: Turn the VOL/SEL/MENU rotary encoder (2) to adjust the bass level from “+7” to “-7”.

•TREBLE: Turn the VOL/SEL/MENU rotary encoder to adjust the treble level from “+7” to “-7”.

•BALANCE: Turn the VOL/SEL/MENU rotary encoder to adjust the balance from “R7” (full right) to “L7” (full left).

•FADER: Turn the VOL/SEL/MENU rotary encoder to adjust the fader from “F7” (full front) to “R7” (full rear).