Jensen VM8013 operation manual Wiring, Sat Bus

VM8013

WIRING

SAT BUS

BUS

SAT R (Red)	(Blue)
	Subwoofer Out
SAT L (White)	Parking/Active Low Level Input (Pink)
	Camera In
	(Yellow)
	Video Out 1
	(Yellow)
	Video Out 2
	(Yellow)
	Fuse (15A)
	Camera/Active High Level Input (Green/White)
	+
Antenna	SWC (Steering Wheel Control)
	(Requires PAC SWI-PS Interface Adapter)

IPOD

)	)	Battery
		Connect the yellow wire to the battery
	+
-	(	or 12 volt power source that is always
(
		live. This wire MUST be connected
		for the radio to work.
		Yellow	FILTER
			BOX

Black

Chassis Ground

Rear Line out	R (Red)
Gray	L (White)
Front Line out	R (Red)
Black	L (White)

Power Antenna

Connect to power antenna or amplifier. If not used, tape bare end of wire.

Compatible SAT Tuners:

1.XMD1000 (requires XMC or XMDJEN100 Cable Kit)

2.CNP2000UC

3.SC-C1 and SIRJEN2

Connect the black wire to the factory ground wire. If a factory ground wire is not provided, locate a clean, unpainted metal part of the dash and secure the ground wire with a "ring" terminal and a sheet metal screw.

iPod	NOTE: Video playback not supported for all
(Sold Separately)	iPods. See iPod section for more information.

FRONT

White/Black	White	Gray/Black	Gray
Stripe		Stripe

Blue

Accessory/Ignition

Connect to existing radio wire or radio fuse.

Red

REAR

Green/Black Green Purple/Black Purple

StripeStripe

IMPORTANT!

The pink parking

wire MUST be

connected to the

switched side of the

parking break

circuit (the part that becomes grounded when the brake is applied).

Left Speaker	Right Speaker	Left Speaker	Right Speaker
(Front)	(Front)	(Rear)	(Rear)

NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.

NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.

3