Planar PT1945RW, PT1945S manual Please Note

If you are using a PC running Windows® CE, follow the instructions below:

1.Power on the computer.

2.Make sure that the RS232 or USB cable is connected to the computer.

3.Using Platform Builder, build an image file by following the step-by-step instructions found in the zipped file on the CD-ROM.

If you are using a PC running Linux or Apple® Mac OS, follow the instructions below:

1.Power on the computer.

2.Make sure that the RS232 or USB cable is connected to the computer.

3.Follow the step-by-step instructions found in the zipped file on the CD-ROM.

When changing the Touch Interface (RS-232 or USB), please follow instructions below.

1.Uninstall the touch driver.

2.Re-start the computer.

3.Remove the original Touch Interface (RS-232 or USB).

4.Connect the computer to the Touch Interface (RS-232 or USB) that you would like to use.

5.Load the Touch Driver CD, then follow the step-by-step instructions as show on monitor.

PLEASE NOTE!

Don’t plug in both the RS-232 and USB cables!

Doing so may cause a driver conflict, making your touch screen inoperable.

23