Planar PL2010 manual Technical Support FAQ, Error Message & Possible Solution Cable not Connected

Page 22

TECHNICAL SUPPORT (FAQ) (cont.)

CLOCK (pixel frequency) controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows vertical stripes and the picture has not correct width.

FOCUS adjusts the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances in light picture.

For FOCUS and CLOCK adjustment use “dot-pattern” or win 95/98 shut-down mode pattern.

ERROR MESSAGE & POSSIBLE SOLUTION

CABLE NOT CONNECTED :

1.Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’s screws.

2.Check the signal -cable connection pins for damage.

INPUT NOT SUPPORT :

Your computer has been set to unsuitable display mode. Set the computer

to a display mode given in the Preset Display Modes table.

21

Image 22
Contents PL2010 Page Page Page Table of Contents For Your Safety FCC Class B Radio Frequency Interference StatementPrecautions Special Notes on LCD Monitors General NotesOther Notes General Notes Checking the Contents of the Package FeaturesBefore YOU Operate the Monitor Installation Instructions Power SourceInstallation Instructions Connecting The CablesTilt Adjustment Attaching The Optional Wall Mount Arm not supplied Installation Instructions External Controls Operating InstructionsMenu / Enter Operating Instructions Auto Adjust button / ExitPower Indicator Osd-Lock FunctionHow To Adjust a Setting OSD MessageSRGB DVI Technical Support FAQ BlueError Message & Possible Solution Cable not Connected Technical Support FAQInput not Support Specifications AppendixAppendix Preset Display Modes Connector Pin Assignment 41G200N935 1C6275