General Notes, Special Notes on LCD Monitors

GENERAL NOTES

SPECIAL NOTES ON LCD MONITORS

The following symptoms are normal with LCD monitor and do not indicate

aproblem.

•Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.

•You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

•The LCD panel used in this monitor is a very high technology product with 3,932,160 thin film transistors giving you fine picture details. Occasionally, a few non-active pixels may appear on the screen as a fixed point of red, green, blue, white or black. Please note that this does not indicate a defective panel.

•Due to the nature of the LCD screen, an after-image of the previous screen may remain after switching the image when the same image has been displayed for a long time. The monitor will slowly recover from this.

•LCD monitors have a fixed size & number of pixels. Due to this, an interpolation is necessary to operate the monitor in a relution below it’s native resolution which may slightly degrage the display quality. Therefore, it is highly recommended to operate the monitor at it’s native resolution of 1600 x 1200 @ 60Hz.

OTHER NOTES

•The screen surface is very soft. Do not rub, touch or tap the screen surface with sharp object such as pen or pencil. This contact may scratch or damage the screen. These damages are not covered under the warranty.

•Turn your computer OFF before installing your new monitor. Refer to your computer manual for the proper shut down procedure.

•Save the original shipping carton and packing materials, as they will come in handy if you ever have to ship your monitor.

•For maximum protection, repackage your monitor as it was originally packed at the factory.

•To keep the monitor looking new, periodically clean the case & surface of the TFT-LCD panel with a soft non-fiberous cloth lightly dampened with a glass cleaner. Do not use any paper products to clean the screen. Never spay the glass cleaner directly on the monitor. Never use strong solvents such as thinner, benzene, or abrasive cleaners, since these will damage the case & panel. As a safety precaution, always unplug the monitor before cleaning it.