I. PREPARATION OF VEHICLE INTERIOR
FIGURE 1
3.Remove and retain (1) one screw which secures front O.E. console. Pull downward to release console. See Figure2.
1.Using the rear edge of O.E. console as a reference location, carefully measure & trim headliner as shown. Use a razor knife to score the first layer and scissors to cut remaining layers. Caution:
Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. Wear safety goggles when cutting headliner material. Make sure that the 9" & 7" cuts are centered left to right in vehicle. See Figure 1.
DO NOT OVERCUT HEADLINER.
2.Scribe a center line on the sheet metal roof of the vehicle from front to rear of opening in headliner. This will be used for bracket alignment. See Figure 1.
FIGURE 2
4.Using a 3/8" drill bit, make an access hole in rear of plastic bracket. Caution: Drill toward rear of vehicle. See Figure 3.
5.Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in video system. Connect the white wire to the O.E. pink wire. Connect the black wire to the O.E. yellow/green wire. See Figure 3.
6.Using a test light, test function of lights.
7.Install O.E. console.
FIGURE 3
3