HOW to Optimize the DOS-MODE, Plug and Play

2.6Exit

3.Function 3.1Auto Adjust

Reset to original factory geometry setting 3.2Auto Colour

Reset to original factory color setting 3.3Exit

Adjust the picture Focus.

4.OSD Menu

4.1Language Muti-Language selection.

Chinese / English / French / German / Italian / Spanish / Japan 4.2 OSD H. Pos.

Adjust the horizontal position of the menu. 4.3 OSD V. Pos.

Adjust the vertical position of the menu

4.4 OSD Timer

Adjust Menu appear Time.

4.5Exit

5.Misc

5.1Signal Source

In pout VGA or DVI.

5.2 Mode Select

640×400 / 720×400

640×400 and 720×400 of DOS mode.

5.3 Reset

Reset to original factory color and geometry setting.

5.4 Volume

Adjust the volume just.

5.5Exit

6.Exit

HOW TO OPTIMIZE THE DOS-MODE

1.Get the full screen pattern at MS-DOS mode, type in C:\>EDIT [press enter] You will be in the Dos-Editor screen

2.Press”AUTO”button(at front pane) about 2 seconds, the monitor will do all the adjustment automatically. You can adjust the image manually, If the screen has a flicker or blur, or not fit in the display

3.press ALT-F, and then X to exit from the Dos-Editor screen

If the DOS-MODE characters still have distortion example:

??The picture can't go to full screen

??The background of white pattern has vertical stripe noise

??The character twisted

That means your monitor parameter was in wrong resolution, please check if your VGA-CARD supports 720x400@70Hz

In general, most of the Dos mode was set by VGA-CARD in resolution 720x400@70Hz, but minor was set in 640x400@70Hz

PLUG AND PLAY

Plug & Play DDC1/2B Feature

This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity, and depending on the level of DDC used, communicate additional information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B.

The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information. The DDC2B is a bidirectional data channel based on the I2C protocol. The host can request EDID information over the DDC2B channel.

THIS MONITOR WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN ORDER FOR THIS MONITOR TO OPERATE OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL.

This monitor meets the Green monitor standards as set by the Video Electronics Standards Association(VESA) and/or the United States Environmental Protection Agency(EPA) and The Swedish Confederation Employees(NUTEK). This feature is designed to conserve electrical energy by reducing power consumption when there is no video-input signal present.