Memorex MM1740 user manual Input not Support, Resolution Vertical Frequency

ERROR MESSAGE AND POSSIBLE SOLUTION	APPENDIX
CABLE NOT CONNECTED :	SPECIFICATIONS

1.Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’s screws.

2.Check the signal-cable’s connection pins for damage.

INPUT NOT SUPPORT:

Your computer has been set to unsuitable display mode, Set the computer to display mode given in the following table.

UNSUPPORTED MODE TRY DIFFERENT VIDEO CARD SETTING: Your computer resolution is out of VESA-SPEC

RESOLUTION:

RESOLUTION	VERTICAL	RESOLUTION	VERTICAL
	FREQUENCY		FREQUENCY
640×480	60Hz	800×600	75Hz
720×400	70Hz	1024×768	60Hz
640×480	72.8Hz	1024×768	70Hz
640×480	75Hz	1024×768	75Hz
800×600	56.3Hz	1024×768	74.92Hz
800×600	60.3Hz	1280×1024	60Hz
800×600	72.2Hz	1280×1024	75Hz

	Driving system	TFT Color LCD
	Size	43cm(17”)
LCD Panel
	Pixel pitch	0.264mm(H)×0.264MM(V)
	Viewable angle	140° (H)130° (V)
	Response time	16ms
	Video	R,G,B Analog Interface
	Separate Sync.	H/V TTL
Input
	H-Frequency	30kHz-80kHz
	V-Freauency	55-75Hz
	DVI	DIGITALIN
Display Colors		16M Colors
Brightness		300cd/m2
Contrast		450;1
Max. Resolution		1280×1024
Plug & Play		VESA DDC1/2BTM
Input Connector		D-Sub 15pin
Input Video Signal		Analog:0.7Vp -p(standard), 75OHM,Positive
Maximum Screen Size		Horizontal:380.16mm Vertical:304.1mm
Power Source		100~240V AC,50~60Hz
Environmental Considerations		Operating Temp:0° C to 40° C Storage Temp:-20
		° C to 60° C Operating Humidity:10% to 85%.
Weight (N.W.)		4.2kg

7