Accompanying drawings | POSIFLEX Business Machines LM-2010, LM-2110

accompanying drawings.


Screw Hole Cover		Screw Hole		VGA Cable Hole Cover
Bridge	HT Cable Cover		Pole Cover	Bridge

Use proper tool to cut the bridges off with the screw hole cover and VGA cable hole cover from the top cover and pole cover at points indicated by each pair of arrows in the drawings. Sand/Cut smooth the inside of the holes resulted.

In the HT system, please arrange the VGA power to be supplied through the interface cable from the main unit through internal jumper setting change with reference to its technical information by a qualified technician.

Connect and screw the video interface cable to the VGA port. The monitor will always turn ON whenever power is made available from the HT system. Use 4 fixing screws to fit the bottom of

LM-2010 supporting bracket to HT system base top as arrowed in the right

picture and have the VGA cable pass through the VGA cable hole as circled in the same picture.

Please note that for LM-2010 with a 2-digit system revision number, the screw holes on support bracket base look like the below left picture and the LM-2010 can be fixed to straight backward of the HT or PB system. For LM-2010 with 3-digit system revision number (3rd digit being “a”) or later, the bracket base is like the

right picture and the LM-

2010 can be swiveled to within +/- 30 degrees from the straight backward

direction for best installation in application

environment before fixing tight the screws.

Part 3